Table of Contents
Advertisement
Quick Links
BSE-150
ACTIVE INDOOR AND OUTDOOR
ACTIVE INDOOR AND OUTDOOR
ACTIVE INDOOR AND OUTDOOR
INFRARED BARRIER WITH
INFRARED BARRIER WITH
INFRARED BARRIER WITH
3 BEAMS OF PROTECTION
3 BEAMS OF PROTECTION
3 BEAMS OF PROTECTION
INSTALLATION
INSTALLATION
INSTALLATION
Instruction Manual BSE-150
ENGLISH
MANUAL
MANUAL
MANUAL
Pag. 1
Advertisement
Table of Contents
Summary of Contents for 3i BSE-150
- Page 1 ACTIVE INDOOR AND OUTDOOR ACTIVE INDOOR AND OUTDOOR INFRARED BARRIER WITH INFRARED BARRIER WITH INFRARED BARRIER WITH 3 BEAMS OF PROTECTION 3 BEAMS OF PROTECTION 3 BEAMS OF PROTECTION INSTALLATION INSTALLATION MANUAL MANUAL INSTALLATION MANUAL Instruction Manual BSE-150 Pag. 1...
-
Page 2: Product Discription
ENGLISH 1 - Product Discription The BSE-150 is an active indoor & outdoor infrared detector with 3 beams of protection. It has regulations for : Vertical axial from (+10° to –10°), Horizontal axial from (+90° to –90°), and for the trigger response time from 1 to 5 (See Par. 5). -
Page 3: Installation Precautions
Avoid mounting the unit in direct sun light or high luminosity light sources. Avoid that a receiver can, by error, receive the signal transmitted form the the wrong unit. See below: Trasmitter Trasmitter Receiver Receiver Trasmitter Receiver ERROR CORRECT Trasmitter Receiver Instruction Manual BSE-150 Pag. 3... -
Page 4: Installation Procedure
3.1.4 Fix to the wall the metal base of the sensor. 3.2.4 See below how to fix 2 units to the same column. 3.1.5 Connect the cable to the desire terminal blocks See fig. page 2 for terminal conn. Pag. 4 Manuale istruzioni BSE-150... - Page 5 Vertical regulation Riceiver screw. High Left Right Replace the front cover and test if the active infrared barrier is functio- horizontal ning correctly. If not,it must be regulation, rotate the recalibrated. lens body as desired. Instruction Manual BSE-150 Pag. 5...
- Page 6 Verify the effects on the barrier based on the selected walk. If you are not satisfied with the results, change this regulation until you obtain the best possible results. 6 - Dimension Material for fixing to support column 95mm 89mm Fixing holes 4,5mm Support Column 55 mm Pag. 6 Manuale istruzioni BSE-150...
-
Page 7: In Case Of Problems
SENSOR MATERIAL....WEIGHT......Trasmitter 630 g - Riceiver 660 g Instruction Manual BSE-150 Pag. 7... - Page 8 For any problems contact the nearest authorized Tre i Systems sales office or service center. Tre i Systems reserves the right to change or make improvments to this product without previous notice. Last revision 07-02-2013 Pag. 8 Manuale istruzioni BSE-150...