Table of Contents
Advertisement
About This Section
The purpose of this section is to guide you
through the required steps to get your machine
out of its packaging and into operating condition.
This equipment pres-
ents serious injury haz-
ards to untrained users.
Read through this entire
manual to become famil-
iar with the operating
procedures before using
this equipment!
Wear safety glasses dur-
ing the entire setup pro-
cess!
Unpacking
Your machine was carefully packaged for safe
transportation. Remove the packaging materials
from around your machine and inspect it. If you
discover any damage, please call us immediately
at (570) 546-9663 for advice.
Save the containers and all packing materials for
possible inspection by the carrier or its agent.
Otherwise, filing a freight claim can be difficult.
When you are completely satisfied with the condi-
tion of your shipment, inventory the contents.
-6-
SECTION 2: SET UP
Clean-Up
1.
Remove the box from around the Model
G0556/G0557 Pan and Box Brake.
2.
Clean the protective coating from machine
surfaces. Note—Use a mild solvent and soft
rag. Thinners, gasoline, acetone ect. will
damage painted surfaces.
3.
Place a light coat of machine oil on all
machined surfaces to prevent rust.
Mounting
1.
Before mounting the Model G0556/G0557 to
a flat and level work surface, make sure the
mounting surface is solid enough to hold the
pan and box brake and the work material.
2.
Place the pan and box brake onto the work
surface and make sure adequate work room
has been given on all sides.
3.
Using a pen or pencil, transfer the hole loca-
tion to the mounting surface.
4.
Mount the pan and box brake to work surface
using
/
" bolts.
5
16
Model G0556/G0557 (Mfg. since 10/04)
Advertisement
Table of Contents
