Qmaster TESE User Manual

TESE 6 cell Battery Pack User's Manual

ON/OFF switch

The pack has a switch on the side (see picture). It is
NOT used to switch the pack on and off. Instead it
controls the automatic switch off function. When
positioned to ON, the function is turned on meaning
the pack will automatically switch off when no current
is detected. When using the pack with a Qmaster
Senior, this will make the pack switch off shortly after
the fan stops spinning..... This is something you don't
want, as the Qmaster Senior will no longer receive
power and will not be able to do anything anymore.
Therefore, (put and) leave it in OFF...

Ports

The unit has for ports at it's base.
Two USB ports for charging devices like mobile
phones (5V selection is required to use them)
One port for charging the pack (second port from the
left, the bigger round port)
One port for connecting to Qmaster Senior (second
port from the right, the smaller round port)
Two cables are supplied, one USB type for charging
the pack and one for connecting Qmaster Senior.

Recharging the pack

Put the supplied USB cable into a USB charger,
preferably a somewhat bigger one like an iPad
charger. A lot of power goes into the pack generating
some heat in the charger. Bigger chargers can cope
with that.
Now put the other end into the bigger round connector
at the base of the pack. The pack will start recharging
regardless of wether it was switched on or off. A LED
will start flashing, indicating the current recharging
status. When all LEDs are on and stopped flashing,
the pack is full.