Mio Smart Box II Installation Manual

Smart Box II
Installation Guide
Revision: R00
(8/2016)
Trademarks
All brand and product names are trademarks or registered trademarks of their respective companies.
Disclaimer
Specifications and documents are subject to change without notice. MiTAC does not warrant this document
is error-free. MiTAC assumes no liability for damage incurred directly or indirectly from errors, omissions, or
discrepancies between the device and the documents.
Notes
Not all models are available in all regions.
Depending upon the specific model purchased, the colour and look of your device and accessories may not
exactly match the graphics shown in this document.
Regulatory information
For regulatory identification purposes, the Mio™ Smart Box is assigned a model number of N467. Hereby,
MiTAC declares that this N467 is in compliance with the essential requirements and other relevant provisions
of Directive 2014/30/EU. Visit Mio website (www.mio.com) for the full text of the declaration for your device.
WEEE
This product must not be disposed of as normal household waste,
in accordance with the EU directive for waste electrical and
electronic equipment (WEEE – 2012/19/EU). Instead, it should be
disposed of by returning it to the point of sale, or to a municipal
recycling collection point.
Introduction
Mio™ Smart Box II provides power to your MiVue™ recorder by connecting with the constant power of the
fuse terminal of your vehicle. It is very useful when you want to record video footage whilst parking. Smart
Box II can prevent the discharge of the vehicle battery by blocking the electric power automatically as it
checks the preset time and voltage.
Parts and functions
1
Time and voltage setting switches
Passenger car/RV:
Truck/bus:
2
ƒ Switch 1 and 2: Voltage setting switches
ƒ Switch 3 and 4: Time setting switches
1 ON / 2 ON 1 OFF / 2 ON
11.8V
23.6V
3 ON / 4 ON 3 OFF / 4 ON
12 hours
5 6 1 5 N 4 6 7 0 0 5 2
1 Fuse cable
- ACC (red wire)
3
- B+ (yellow wire)
- GND (black wire)
2
Main unit of Smart Box II
- Time and voltage setting switches
- LED indicator
3 Mini-USB connector
Connects to the recorder.
1 ON / 2 OFF
12.0V 12.2V
24.0V 24.4V
3 ON / 4 OFF
24 hours 36 hours
R 0 0
1 OFF / 2 OFF
11.6V
23.2V
3 OFF / 4 OFF
power off