Nixzen NX-N-UTP3-MC01-DS20KM User Manual

Fast Ethernet Converter
This is the fast Ethernet optical transceiver which can convert two different transmission medium between
network cable and optical fiber. It supports 10/100Mbps bandwidth. This product can use in pair or work
with other device, it's widely used in surveillance monitor, FTTH and other situation.
Application
Feature
Provide 100Mbps optical port and Ethernet port, network data can
Adopts X9 optical transceiver, SC connector, use single mode double fibers, transmission distance up to
20km;
Compatible with IEEE 802.3 10BASE-T, IEEE 802.3u 100BASE-TX/FX Ethernet standard;
Support 10/100Mbps full/half duplex auto adaptive, support auto MDI/MDIX;
Power adapter use aviation connector, more stable and resalable;
Dynamic LED indicator, real-time show the working status, provide simple working status indication and
trouble shooting;
Delicate aluminum structure design, convenient for desktop and wall installation.
Note
Please attention two optical fibers need to cross-linking two fast Ethernet converters's optical ports;
1
switch between Ethernet and optical;
Board Diagram
Left
Optical Port Power and Optical
Ethernet Port
Right
POWER
5VDC
Power Input
Description
1 ) Power is power indicator ; FED, SD, LINK is optical fiber port indicator, they mean:
Link: indicate optical port connection status, On: connection ok; Off: connection failed; flash: connection OK and data
switching.
SD: optical port signal detection, On: Optical fiber connection right; Off: Without optical fiber connection.
FED: remote failure mode receive, On: 80ms Off: 20ms Always off: no receive.
2) LED failure indication function, please refer to the below table:
Optical Port Optical Port Optical Port
Ethernet LED
Link SD
On On On
Flash Flash On
Off Off On
Off Off Off
Off Off On
Installation Step
Please check the following items before installation, if any missing, please contact your dealer.
Fast Ethernet Converter
Power Adapter
Hangers
User Manul
Please follow the following installation steps
1) Please turn off the signal source and the device's power, installation with power on may damage the
device;
2) Please check if the network cable and other transmission line are occupied by other device;
3) Use a network cable to connect with fast ethernet converter's LAN port and NVR or computer;
4) Use two single mode double optical fibers to connect with two fast Ethernet convert's optical port, attention
the fiber connect with RX and TX need to be cross connection. That means to use one fiber to connect with
optical transceiver's TX, and the other side to connect with the RX;
5) Check if the installation is correct and device is good, make sure all the connection is reliable and power
for the system;
6) Make sure the network is normal.
Fast Ethernet Converter
Power
FED FED
SD SD
Link
Link
Fiber
Indicator
Status
FED
Off Connection good
Off Connection Good and has data switch
Off Remote Ethernet port can't connect
Off Fiber RX off line, fiber TX/RX off line
Flash Fiber TX off line
1pc
1pc
2pcs
1pc
2