Enerwave ZWN-BPC Installation Instructions

INSTALLATION INSTRUCTIONS
PIR Motion Sensor

SPECIFICATIONS

Power Supply....................................................................2AA batteries
PIR Sensitivity Adjustment....................................25%/50%/75%/100%
Test Mode...................................................................................15 sec.
Operation Temperature...........................................................32-104°F
PIR Detection Coverage..................................................... Up to 600ft
Z-Wave Frequency..................................................... 908.42MHz(US)
RF Range...................................................Up to 100 feet line of sight

FEATURE

Adopt wireless RF technology
360 degree ceiling mounted cover up to 600ft
Low battery detection
Adjustable PIR Sensitivity
LED motion indicator
Support Z-Wave associations, sending commands up to 5
associated Z-Wave devices
For indoor use only

DESCRIPTION

The PIR Motion Sensor ZWN-BPC is a Z-Wave enabled device and is
fully compatible with other Z-Wave certified device. This device is
typically used in conjunction with the ZWN-BDS to monitor the
environment and provide hand-free lighting control, it can also trigger
a Z-Wave enabled alarm when motion is detected.
This sensor acts as a security device by detecting changes in infrared
radiation levels. when some body moves within or across the detection
of coverage, one triggering signal will be transmitted to associated
Z-Wave devices.

COVERAGE PATTERN

The ZWN-BPC provides a 360° coverage pattern, up to 600 square
feet. The coverage shown represents walking motion at a mounting
height of 8 feet( See Figure 1 ). For building spaces with lower levels
of activity or with obstacles and barriers, coverage size may decrease.
Figure 1
8 ft
Typical
desk-top
level
13 ft 7 ft 3 ft 0 3 ft 7 ft 13 ft
- 01-
ZWN-BPC

PLACEMENT

Ceiling Mounted
Place of PIR Motion Sensor:
It is very important to place the sensor with 6-7 feet from the primary
location, at least 8 feet away from the possible false triggering area.
Hotel Room :
2
2
Air-conditioner
Private Office :
26ft
8m
Bath Room
PIR Motion Sensor
Sitting Spot, a Chair or a Coach
Figure 2
PIR Motion Sensor
8 to 9 feet
Air Vent
Figure 3
-02-

INSTALLATION

1.The PIR Motion Sensor consists of two parts: Attachment Base and
Motion Sensor.
2.Place Attachment Base on ceiling by using both screws and adhesive
pad.
3.Insert the two AA batteries noting the proper orientation.
4.Lock the Motion Sensor by twisting onto the base.
Attachment Base
Motion Sensor

ADJUSTMENT

DIP Switch
Sensor Sensitivity Range
Adjustable: 25%/50%/75%/100%
PIR Sensitivity
DIP Switch
25%
50%
75%
100%
-03-
Ceiling
Adhesive Pad
Screw
Figure 4
Program Button