Tine Removal And Installation - Remington Garden Wizard 109312-01 Owner's Manual

ELECTRIC TILLER
ASSEMBLY
Continued
ADJUSTING WHEEL
ASSEMBLY
Adjusting the Wheel Assembly
for Transport
1. Remove retaining clip and clevis pin
from wheel assembly mounting bracket
(see Figure 5).
2. Rotate the wheel assembly down so that
the hole in the wheel assembly lines up
with the center hole in the mounting
bracket as shown in Figure 6.
3. Insert the clevis pin through the hole as
shown in Figure 6, and insert the retain-
ing clip in the clevis pin. The wheels are
now mounted in the transport position.
Retaining Clip
Figure 5 - Removing Retaining Clip and
Clevis Pin
Figure 6 - Adjusting Wheel Assembly to
Transport Position
For more information, visit www.desatech.com
®
Adjusting the Wheel Assembly
for Tilling
1. Remove the retaining clip from the
clevis pin and remove the clevis pin
from the mounting bracket and wheel
assembly.
2. Rotate the wheel assembly up and for-
ward as shown in Figure 7 until the hole
in the wheel assembly lines up with the
upper hole in the mounting bracket.
3. Insert the clevis pin through the aligned
holes and insert the retaining clip into
the clevis pin. The wheels are now
mounted in the tilling position.
Clevis Pin
Figure 7 - Adjusting Wheel Assembly to
Tilling Position
TINE REMOVAL AND
INSTALLATION

Tine Removal and Installation

1.
2. Remove outer tine set from tine shaft.
3. Remove inner tine set from tine shaft.
4.
5.
Outer
Tine Set
Rotation of Tines
During Operation
Figure 8 - Tine Removal and Installation
6
WARNING: Always unplug the
tiller before placing hands near
the tines. Always wear gloves to
protect your hands from the sharp
edges of the tines.
IMPORTANT: The tiller has 4 dif-
ferent sets of tines. For proper
performance, the tines must al-
ways be installed correctly as
shown in Figure 8. When as-
sembled correctly, the angled cut-
ting edge of tines should rotate
towards the front of the tiller. The
blades of all the tines should be
pointing toward the transmission.
The tine hubs of the inner and
outer tine sets should be facing
each other as shown in Figure 8.
Remove the retaining clips from the end
of the tine shaft.
Reinstall the retaining clips onto tine shaft
to prevent them from being misplaced.
Reverse above steps to install tines.
Tine Hubs
Toward Transmission
Retaining Clip
Tine
Blade
Inner Tine Set
Tine Hub
Tine Shaft
Cutting
Edge
109363