Table of Contents
Advertisement
Thank you for purc hasing t his product. For optimum performance and safety, please read
these instructions carefully before connecting, operating or adjusting this product. Please keep
this manual for future reference.
SURGE PROTECTION DEVICE RECOMMENDED
This product contains sensitive electrical components that may be damaged by electrical
spikes, surges, electric shock, lightning strikes, etc. Use of surge protection systems is highly
recommended in order to protect and extend the life of your equipment .
1. The transmission distances of HDMI over UTP cables are measured using TE
CONNECTIVITY 1427071-6
2.
EIA/TIA-568-B termination (T568B) for CAT cables is recommended for better
performance.
3. DO NOT use 568A/568B standard mixed CA T cable (cross-over cable) because there are
2 pairs swapped, this will make POE OVE R-CURRENT and damage POE components.
Please use straight-through CAT cable (both RJ45 headers are 568A or 568B standard).
4. It is recommended that power up t he device after connections of source, sink and CA T
cable.
5. To reduce the interference among the uns hield ed twisted pairs of wires in CAT cable, do
not run HDB aseT / Zone Cat5e/6/6a cabling with or in close parallel proximity to mains
power cables. Shielded CA T cables can be used to improve EMI problems, which is
worsen in long transmission.
6. Because the quality of the CA T cables has the major effect on how long t he transmission
limit can achieve and how good is the received picture quality, the actual transmission
range is subject to one's choice of CAT cables.
7. Do not substitute or use any other Power S upply other than the enclos ed unit, or a Factor
Electronics approved Replacement Part. Doing so will void the warranty and potentially
expose the user to dangerous voltages resulting in an electrical shock.
8. Do not disassemble the device for any reason. Doing so will void the manufacturer's
warranty. Also, our unique case is an integral part of the design of this unit and is
responsible for cooling and circuitry shielding. Any modifications to this case will
potentially cause malfunction and product failure.
9. Do not expose the device to water, moisture, or liquids. Possible electric shock may result
as well as failure of the unit to operate.
www.factorelectronics.com
SAFTY AND NOTICE
2
HD100BaseT-Balun User Manual
Factor Electronics
Advertisement
Table of Contents
