Related Manuals for Monoprice 7337
Summary of Contents for Monoprice 7337
- Page 1 Ceiling Recessed Projection Screen P/Ns 7337, 7338, 7951, 30451, 30452, 30453 User's Manual...
-
Page 2: Table Of Contents
CONTENTS SAFETY WARNINGS AND GUIDELINES ............................3 Installation and Operation ................................3 General ..........................................3 Power ..........................................4 CUSTOMER SERVICE ....................................5 PACKAGE CONTENTS ....................................5 PRODUCT OVERVIEW ....................................6 INSTALLATION ........................................6 WIRING ............................................ 9 TENSION ADJUSTMENT ..................................10 UP AND DOWN LIMITS .................................... -
Page 3: Safety Warnings And Guidelines
SAFETY WARNINGS AND GUIDELINES Please read this manual thoroughly, paying extra attention to these safety warnings and guidelines. Keep this manual in a safe place for future reference. Installation and Operation This product should only be installed by a qualified structural contractor. Failure to follow proper structural code in regard to hanging equipment could result in serious injury or death. -
Page 4: Power
Do not place or install this device in an area where it can be exposed to excessive amounts of dust, humidity, oil, smoke, or combustible vapors. When it is extended, take care not to shake the screen or attempt to manually lift it ... -
Page 5: Customer Service
If you have any problem with your order, please give us an opportunity to make it right. You can contact a Monoprice Customer Service representative through the Live Chat link on our website www.monoprice.com during normal business hours (Mon-Fri: 5am-7pm PT, Sat-Sun: 9am-... -
Page 6: Product Overview
PRODUCT OVERVIEW INSTALLATION 1. Measure, mark, and cut the ceiling cut-out. The cut-out dimensions depend upon the size/model of screen you have. Model A: 7951, 30453 (≥150") Cut-out Length = Screen Length - 26mm Cut-out Width = 150mm ... - Page 7 Model B: 7337, 7338, 30451, 30452 (<150") Cut-out Length = Screen Length - 26mm Cut-out Width = 115mm Height ≥ 120mm 2. Carefully measure the distance from the closest wall to the center of the screen. 3. Verify the length of the screen size by measuring the distance between the center of the two screw holes on the upper left and upper right brackets.
- Page 8 7. Carefully lift the screen assembly to insert the threaded rod through the upper screw hole. Attach a safety nut 3-4" up the threaded rod. Repeat for the other side. 8. Adjust the safety nut so the threaded rod goes through the lower screw hole. Loosely attach the lock nut.
-
Page 9: Wiring
WIRING Warning! Please unplug the receiver/power module before opening to make changes. The receiver must be wired to an AC power source and to the motor prior to operation. Use the information in the following table to wire the power source, motor, and an external switch (optional). -
Page 10: Tension Adjustment
TENSION ADJUSTMENT (Models 30451, 30452, and 30453 only) To adjust the tension, push the adjustment key into the adjustment hole, then push in and turn. Turn it clockwise to tighten the tension and counterclockwise to loosen the tension. -
Page 11: Up And Down Limits
UP AND DOWN LIMITS The screen up and down limits are set at the factory, so normally there is no need to adjust them. However, if the need arises, use the included adjustment key to adjust the up and/or down limits. ... -
Page 12: Rs-232/Rs-485 Control
RS-232/RS-485 CONTROL You can use a computer with RS-232 or RS-485 control to raise and lower the screen. The communications protocol is: Data Bits: 8 digits Initial Digits: Digit 1 Stop Digits: Digit 1 Baud Rate: 2400 0xFF 0xEE 0xEE 0xEE 0XDD STOP: 0xFF 0xEE 0xEE 0xEE 0XCC DOWN:... -
Page 13: Programming And Clearing The Remote
PROGRAMMING AND CLEARING THE REMOTE (Models 30451, 30452, and 30453 only) If you wish to use a remote control other than the one provided, you will need to ensure that it is an RF remote (not IR) operating at 868 MHz. You will then need to "program" the system to recognize the remote. -
Page 14: Removing The End Caps
If you need to remove the end caps, insert a paper clip into the end cap disassemble hole. TECHNICAL SUPPORT Monoprice is pleased to provide free, live, online technical support to assist you with any questions you may have about installation, setup, troubleshooting, or product recommendations. -
Page 15: Specifications
SPECIFICATIONS Model 7337 Screen Size 106" Aspect Ratio 16:9 Remote Control Type Screen Material Fabric Screen Color Matte white Screen Gain Viewing Angles 160° Viewing Area 92.4" x 52.0" (2346 x 1320 mm) Total Screen Height 79.5" (2019mm) Left/Right Borders 2.0"... - Page 16 Model 7338 Screen Size 120" Aspect Ratio 16:9 Remote Control Type Screen Material Fabric Screen Color Matte white Screen Gain 1.0" Viewing Angles 160° Viewing Area 104.6" x 58.8" (2656 x 1494 mm) Total Screen Height 79.3" (2013mm) Left/Right Borders 2.0"...
- Page 17 Model 7951 Screen Size 150" Aspect Ratio 16:9 Remote Control Type Screen Material Fabric Screen Color HD white Screen Gain 1.0" Viewing Angles 160° Viewing Area 130.7" x 73.5" (3320 x 1867 mm) Total Screen Height 86.5" (2197mm) Left/Right Borders 2.0"...
- Page 18 Model 30451 Screen Size 106" Aspect Ratio 16:9 Remote Control Type RF (868 MHz) Screen Material ISF Ultra HD Screen Color White Screen Gain Viewing Angles 160° Viewing Area 92.4" x 52.0" (2346 x 1320 mm) Total Screen Height 69.9" (1776mm) Left/Right Borders 3.1"...
- Page 19 Model 30452 Screen Size 120" Aspect Ratio 16:9 Remote Control Type RF (868 MHz) Screen Material ISF Ultra HD Screen Color White Screen Gain Viewing Angles 160° Viewing Area 104.6" x 58.8" (2656 x 1494 mm) Total Screen Height 76.8" (1950mm) Left/Right Borders 3.1"...
- Page 20 Model 30453 Screen Size 150" Aspect Ratio 16:9 Remote Control Type RF (868 MHz) Screen Material ISF Ultra HD Screen Color White Screen Gain Viewing Angles 160° Viewing Area 137.7" x 73.5" (3320 x 1867 mm) Total Screen Height 91.5" (2323mm) Left/Right Borders 3.1"...
Need help?
Do you have a question about the 7337 and is the answer not in the manual?
Questions and answers