Table of Contents
Related Manuals for Neilsen CT0672
Summary of Contents for Neilsen CT0672
- Page 1 AIR IMPACT WRENCH 1/2” Drive CT0672 ORIGINAL INSTRUCTIONS Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.
-
Page 2: Ec Declaration Of Conformity
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: AIR IMPACT WRENCH Model: CT0672 Applicable EC Directives: EC Machinery Directive 2006/42/EC Harmonized standards EN ISO 11148-6 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS SYMBOLS In this manual and/or on the machine the following symbols are used: Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance of the instructions in this manual. Wear hearing protection. Wear safety goggles. -
Page 4: Tool Use And Care
2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or long hair increases the risk of injury to persons as a result of being caught in moving parts. 3. -
Page 5: Specifications
SPECIFICATIONS Max. speed:7000/min Ultimate torque:230ft/lb Air consumption:5cfm Max. air pressure: 6.2bar Air inlet:1/4" Net weight(without accessories): 2.1kg OPERATING INSTRUCTIONS Figure .1 – Airline Oiler Step 1: Set the compressor’s pressure regulator to a maximum of 90 PSI. 90 PSI is satisfactory without harming this tool. - Page 6 Step 5: Select the power setting for Loosening by adjusting the AIR REGULATOR (#36) located on the bottom of the Impact Wrench as shown in Figure 3. When the Air Regulator is completely screwed in it is at it’s lowest setting. Air pressure increases as you loosen the Air Regulator.
-
Page 7: Maintenance
Loosening Step 1: Verify that the power level is correct for your needs and that the REVERSE VALVE (#42) has been shifted (pressed) completely to the right. If not, refer to Steps 5 through 9 under Use before proceeding. Step 2: Place your work in as clear a location as possible. Make sure the air hose will reach as far as needed without stressing any connections. -
Page 8: Assembly Diagram And Parts List
ASSEMBLY DIAGRAM AND PARTS LIST Parts No. Description Quantity Parts No. Description Quantity Protecting Rubber Washer Housing Screw Screw Rubber Anvil Bushing Screw Anvil Collar and Seal Exhaust Deflector ―O‖ Ring Screw Anvil(1/2‖ SQ) Spring Hammer Pin Hammer Dog Trigger Hammer Cage Drive Cam Screw...