Advertisement
1. EndoCam Camera
2. Snapshot button
3. Brightness button
4. LED Indicator
5. Power ON/OFF
Button
6. EndoCam
Camera Head
7. Battery
8. USB Cable
9.
Charge
310K Pixels camera.
Press button to take a snapshot.
Hold button down for 1-2 seconds to start
video recording.
Light intensity of 10 segments
When you reach the brightest when the
lights will flash
Go back from 9 to 0 after the cycle
Non-connection with USB cable
• Power on :Blinking 45sec. to access into Wi-Fi Mode
• Sanpshot
:Blink once
• Recording
:Blinking continually
• Stop recording :Stop blinking & back to
•
Low Battery: Blinking continually and need recharge
immediately
EndoCam Camera Head disconnection: Blinks
•
for 5 sec. then powers off automatically (After
camera head connection is normal, press the power
button and restart again)
Connection with USB cable
Fully Charge (keep charging 1-2 hrs.)
Charging
Press 3 second to power ON.
Press 1 second to power OFF.
Camera and LED light module.
Location where rechargeable battery is
placed into the unit.
Micro USB port at the bottom of the unit.
Support operating time up to 2.5 hours
per each full charge.
on
Advertisement
