Cleaning And Care - Clatronic MD 2704 Instruction Manual

Water jet

Hide thumbs

Table Of Contents

Table of Contents

Available languages

4....-05-MD 2704

1. Your water jet can also be installed on the wall.

2. To do so, attach the supply mounting to the wall.

3. You can then insert your water jet from the top to the bottom.

1. Fill the water container with water.

2. Turn the regulator to the maximum setting. Then switch on the device on the

handle.

3. Drain the water into the wash basin.

4. Rinse the nozzle attachments briefly under running water.

There is a choice of two nozzles: a single jet nozzle and a multiple jet nozzle.

•

The single jet nozzle is used for thorough cleaning (concentrated on one point)

of the spaces between the teeth.

•

The multiple jet nozzle is used for preliminary and general cleaning, as well as

massaging the gums.

1. Before using the water jet you should clean your teeth with a toothbrush.

2. Attach a nozzle on the handle in such a way that the aperture of the nozzle is

pointing at the water stop button. Ensure that the nozzle is fixed firmly in posi-

tion.

3. Fill the water container with water which is hand warm. Please do not fill in any

hot water.

4. In order to clean the nozzles, allow water to flow through the nozzle head (at

maximum water pressure) into the wash basin before and after each time the

device is used.

5. Then use the water pressure regulator to select the desired water pressure. Be-

gin on the smallest setting, especially if you have problems with bleeding of the

gums or when the water jet is used by children.

6. Make sure that you hold your head above the wash basin. Pass the nozzle

along the gums and teeth.

7. After use, please turn the water pressure regulator back to position "0".

8. Turn the device off on the handle.

9. Please clean the device as described under "Cleaning and Care".

1. Before cleaning the water jet, remove the mains plug from the socket. The hou-

sing and mains supply must not be cleaned or immersed in water. The housing

should only be wiped off with a moist soft cloth.

11.06.2002 12:46 Uhr

Attaching the Wall Mounting

Before Initial Use

Nozzles

Operation