Advertisement
Reed Speed Sensor and Magnet:
1.This sensor is universal sensor for motorcycle, find a rotating part to install magnet (for example disk, sprocket or driveshaft) and
a location to install the sensor where it can be aligned to the magnet.
2.Align the center of the magnet to either of the sensor marking lines or the side of the sensor. The magnet must not travel down
the body of the sensor
3.Installing the sensor parallel to the vibration direction creates optional anti-vibration effect.
4.Make sure the gap between the magnet and the sensor is within 8mm.
1.Setup operations include 12/24HR clock, wheel circumference and units. You have to set up step by step. The computer will automatic reversion to main
screen if no button operation for 20 seconds at any setting screen.
2.Press both MODE & RESET buttons to go into setting mode.
3.In setting mode, each press of the RESET button increments the flashing digit by 1 or converts units. Press MODE button to confirm the digit setting and
warning jump to next digit or next setting screen to be set. Press MODE button for 2 seconds at any setting screen to finish the setting and go to normal
mode.
4.It displays "12 or 24H and XX:XX-XX" symbols and AM/PM in case you select 12H. Operates buttons as descriptions of item 3 to finish bar-graphic
speedometer scale setting and jump to wheel circumference setting screen.
5.It displays "cXXX", "c" means "Circumference", following 4 digits is circumference of original tire; flashing digit is digit to be reset. Operates buttons as
descriptions of item 3 to finish bar-graphic speedometer scale setting and jump to units setting screen.
6.It displays KM/h or M/h, eachpress of RESET button converts unit; press MODE button to confirm unit setting and jump to clock setting screen or hold the
MODE button for 2 seconds to complete the setting and return to normal mode.
MODE
+
RESET
+
2 Sec
MODE
2 sec
1. Do not use chemical solvent, thinner to clear the housing and transparent lens to avoid damage of lens and housing.
2. The LCD will display slow when temperature below 0℃/32℉, unit will return to normal state when the temperature rises.
Installation
Clock,Wheel and Units SETUP
MODE
RESET
MODE
PRECAUTION
MODE
MODE
MODE
MODE
MODE
RESET
MODE
MODE
MODE
Advertisement
