Keyless (Pushbutton) Start - Chevrolet 2018 TRAVERSE Getting To Know Your

KEYLESS (PUSHBUTTON) START

The Remote Keyless Entry transmitter must
be in the vehicle to turn on the ignition.
STARTING THE ENGINE
With the transmission in Park or Neutral,
press the brake pedal and then press the
ENGINE START/STOP button. The button
indicator will be green.
Note: If the transmitter battery is weak, place the transmitter in the pocket in the center console
storage compartment to enable the engine to start. Replace the transmitter battery as soon as possible.
STOPPING THE ENGINE/OFF
Shift to Park and press the ENGINE START/STOP button.
ACCESSORY MODE
With the engine off and the brake pedal not depressed, press the ENGINE START/STOP
button to place the ignition in accessory mode. The button indicator will be amber.
AUTO ENGINE STOP/START OPERATION
The fuel-saving engine stop/start system automatical-
ly stops and restarts the engine to help conserve fuel.
The system may turn off the engine, referred to as an
Auto Stop, when the brake pedal is pressed and the
vehicle is at a complete stop, if operating conditions
are met. In Auto Stop mode, the tachometer gauge will
read AUTO STOP. The audio system, climate controls
and other accessories will continue to operate. When
the brake pedal is released or the accelerator pedal is
pressed, the engine will restart. After parking the vehicle and turning off the engine, the
tachometer gauge will read OFF.
The engine may remain running or restart when the vehicle is stopped if:
• A minimum vehicle speed is not reached.
• The engine or transmission is not at the required operating temperature.
• The outside temperature is not in the required operating range.
• The shift lever is in any gear other than Drive (D).
• The battery charge is low.
• The climate control system requires the engine to run based on the current settings.
• The Auto Stop time is greater than 2 minutes.
See Driving and Operating in your Owner's Manual.
See Driving and Operating in your Owner's Manual.
5