Rascal Super User Manual

⊕
To Full Set
To Part Set
To Home Set
To Unset
(No Alarm)
To Reset

(After an Alarm)

Change User PIN
code
Bell Test
Walk Test
1
2 3
4 5 6
Rascal Super
8 9
7
* 0 #
⊕
User Guide
Rascal
Enter your 4-digit PIN code. Exit time will start. Leave premises
X X X X
by designated exit route. System will set automatically on
completion of exit time.
Enter your 4-digit code. Press
X X X X
Isolated zone LED's will flash. System will Part Set automatically
on completion of Part Set exit time.
0
*
Enter your 4-digit PIN code. Press
X X X X
will start. Isolated zone LED's will flash. System will Home Set
automatically on completion of Part Set exit time.
6
*
Enter your 4-digit PIN code to Unset system and revert to 'Day'
X X X X
mode.
Sounders/Strobe operating. Enter your 4-digit PIN code.
X
X X X
Sounders/Strobe silenced. LED's on for zone activation. Re-enter
LED'S ON FOR ZONE ACTIVATION
4-digit PIN code followed by # to reset the system.
X X X X
#
Enter your 4-digit PIN code. Press
X X X X
4-digit PIN code.
1
9
*
Y Y Y Y
Enter your 4-digit PIN code. Press
X X X X
Auto Test. Press
9
*
*
Enter your 4-digit PIN code. Press
X X X X
Test detectors. Press
9
4
*
*
followed by 0. Exit time will start.
*
followed by 6. Exit time
*
then 9, then 1. Enter your NEW
*
then 9. System runs
*
on completion to exit Bell Test.
*
* ,
then 9, then 4 to Walk
on completion to exit walk test.
*
Part No. 320291