Pact CLUB TIMER III Instruction Manual page 3

Press RVW to accept the number and move
to the left (tenths, ones, tens).
When you have the complete par time
entered, press GO to jump back to Timer
Mode. Note that PAR is now lit and the time
you entered is now displayed in the lower left
corner.
When a PAR time is used the FIRST SHOT
feature is disabled. The SPLIT time of the first
shot after the PAR is the time from the PAR
buzzer to the shot. It is the amount overtime,
not the time between shots.
SHORTCUT: A quick way to clear a PAR time
is to enter Set Mode, set your INSTANT/
DELAY, then press GO. No need to set
everything back to zero.
Adjust Sensitivity
With the proliferation of action shooting
disciplines, the sensitivity of the microphone
has become an issue. Set too sensitive,
the timer will pick up shot echoes or even
its own buzzer. Not sensitive enough and
it can miss shots, a real problem with the
low power rounds. We have included an
adjustment located in the corner of the
battery compartment, however, we strongly
recommend that you do NOT mess with it.
Replacing Battery
It's best to change the battery with the timer
on, to insure that it resets properly when the
new battery is installed. Should the time lock
into off mode when you install a new battery
just remove the battery and let the timer sit
for a few minutes to dissipate the internal
charge.