Table of Contents
Advertisement
GENERAL NOTES
LOCATION & VENTILATION
The SMP-2 Microphone Preamplifier must be installed in a stable location with
ample ventilation. It is recommended, if this unit is rack mounted, that you allow
enough clearance on the top and bottom of the preamp such that a constant flow of air
can flow through the ventilation holes.
WATER AND MOISTURE
As with any electrical equipment, this preamplifier should not be used near water or
moisture. If liquid enters the preamplifier, it must be immediately returned to your
dealer for servicing.
SERVICING
The user should not attempt to service the preamplifier beyond that described in the
owner's manual.
Refer all servicing other than tube replacement to QES Labs.
MAINS CONNECTIONS
IMPORTANT:
DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL
OTHER CONNECTIONS HAVE BEEN MADE.
Your preamplifier has been factory set to the correct mains voltage for your country.
The voltage setting is marked on the serial badge, located on the rear panel. Check
that this complies with your local supply.
The power cord must be earthed- 3-pin type.
Advertisement
Table of Contents
