Table of Contents
Advertisement
SUPER SNOW
USER'S GUIDE & INSTALLATION INSTRUCTIONS
SUF-200NW-CK
Safety Information
This product is SINGLE PHASE ONLY.
Do NOT modify to three phase.
Before using your new BARSKOREA SUPER SNOW
Machine, please read this manual thoroughly to
ensure that you know how to operate the features
and functions that your new appliance offers safety
and efficiently.
This product is qualify for international uses.
If you have any question, contact us
at 82-32-581-3466 or email us at
barskorea@hanmail.net
Advertisement
Table of Contents
Summary of Contents for BARSKOREA SUF-200NW-CK
- Page 1 Safety Information This product is SINGLE PHASE ONLY. Do NOT modify to three phase. Before using your new BARSKOREA SUPER SNOW Machine, please read this manual thoroughly to ensure that you know how to operate the features and functions that your new appliance offers safety and efficiently.
- Page 2 Experience The Real Snow With BarsKorea ATTENTION! Before install 'Super Snow Machine' ※ This product is SINGLE PHASE ONLY. Do NOT modify to three phase. TECHNICAL SPECS Model SUF-200NW-CK Ice type Snow shaved/flavored snow ice Cooling Type Air Cooling Hydraulic Pressure 0.05~78 Mpa (0.5~8 Kgf/cm2)
-
Page 3: Table Of Contents
Experience The Real Snow With BarsKorea CONTENTS GENERAL INFO The List of part about SUPER SNOW Warning and Safety 7-15 Warning & Safety Power Related Precaution Precaution 9-13 Cleaning Precaution Other Precaution INSTALLATION METHOD Installation 16-23 Grounding in horizontal installaion... -
Page 4: The List Of Part
THE LIST OF PART Use this page to become more familiar with the parts and features of the Super Snow Machine. SIDE VIEW Liquid Entrance (top of the machine) Alarm Speaker Display Unit Temperature Display Control Panel Handle Side Cover (Left, Right) Front Clear Door Inner Ice Bin... -
Page 5: Back View
BACK VIEW Cleaning Cover PCB Cover Power Switch Power Code Water Filter Hose Air-cooling Discharhger Accessories Silicone Hose Fuse Pan Cover User Manual Stainless Vat NAME OF PARTS 5... -
Page 6: About Super Snow
Stop use the Super Snow Machine with above circumstances • Unplug your Super Snow before making any repairs • Call for service. Service should be performed by a qualified technician. ※ Please do not attemp to repair the machine. 6 About SUF-200NW-CK... -
Page 7: Warning And Safety
IMPORTANT SAFETY SYMBOLS and PRECAUTIONS WARNING Hazards or unsafe practices that may result in severe personal injury or death. CAUTION Hazards or unsafe practices that may result in minor personal injury or property damage. Follow directions carefully. Do NOT attempt. Make sure the appliance is grounded to prevent electric shock. -
Page 8: Power Related Precaution
POWER RELATED PRECAUTION With a dry cloth Unplug the power frequently clean off cord from the outlet any accumulating when not using the dust, water, etc. machine for prolonged periods ▶ Improper of time. maintanence may cause ▶ Improper electrical shock surge protection may causes electrical and/or fire. -
Page 9: Precaution
PRECAUTION Call service center, Do not insert metal for water flooded objects underneath Super Snow the machine. ▶ Fully dry the ▶ May cause machine before use, personal injury. to prevent electrical shock and/or fire. Discard or properly If leaking gas has store the plastic been detected cover from the... - Page 10 Do not touch the Do not disassemble, power plug with repair, or modify. wet hands. ▶ Do not repair ▶ May cause anything except electrical shock. the fuse. Please contact the service center for repair. If control panel Do not pour hot becomes dirty (soil, water into the food waste, etc),...
- Page 11 If the water supply When reinstalling, hose becomes examine the water disconnected from hose connection for the faucet and foreign objects or becomes flooded damage before with water, please connecting. disconnect the power plug ▶ Damage to the machine may occur. ▶...
- Page 12 Do NOT overwork Do NOT operate the machine. the machine with opened water OVER ▶ More than 2 bin inside the hours of machine. continuous operation may ▶ May cause cause mechanical electrical damage to the machine. Vibrations shock and/or injury. may happen due to the overwork.
-
Page 13: Precaution
Do NOT operate Do NOT touch the the machine with inside of the wet hands. machine with bare hands or metal objects. ▶Electrical shock and/or injury may occur. ▶ Electrical shock and/ or injury may occur. Allow at least Do NOT use 39in (100cm) in a hair dryer front of the Super... -
Page 14: Cleaning Precaution
CLEANING PRECAUTION Do NOT spray with Do NOT water directly. use strong acidic Do NOT wipe cleaners off with benzene, ▶ May cause thinner, corrosion to the or alcohol. machine and mechanical damage. ▶ May cause color changes, transform, damage to the machine;... -
Page 15: Other Precaution 15
OTHER PRECAUTIONS ▶ Please maintained the structure attached to Super Snow machine ▶ We do not recommended to use the mechanism not recommended by the technician or over work with the speed defrost system (the system to remove the frost). Could affect or performance of the machine. -
Page 16: 16 Installation Method
TRANSPORT AND INSTALLATION Remove all food and liquid from the Super snow machine. Tap secure the clear door in the closed position. Transport upright over long distances. Transport the machine with two people. (figure reference). Please move the product in a straight direction (front and rear) during installation, repair, and cleaning. -
Page 17: Installation
Please avoid installation in places of direct sunlight and extreme cold. Install within temperatures of 5ºC and high in 25ºC If the temperature is too high or low this may result in an overworked machine. INSTALLATION - GROUNDING METHOD Please ground electical to prevent a short circuit or electric shock. Insure all electical outlets are grounded properly. - Page 18 INSTALLATION METHOD 1. Select the place where you like to install Leave space between 15cm from machine to wall 2. Make the bottom level of the place you want to install and adjust the height Please adjust the plank that can adjust the height. Press the left and right corners during the operation, to check machine is moving The floor surface is horizontal when machine is not shaken...
-
Page 19: Connecting The Water Supply Hose
CONNECTING THE WATER SUPPLY HOSE 1) Connect the water filter as shown on the picture on the left. Do not connect with hot water, cause the mechanical damage Do not use the old water hose. Please connect with the new one that came with this machine 2) Make sure the machine maintains level. - Page 20 If water still leaking, please call BarsKorea service center for the repair. • If the water faucet and the water supply hose are different in sizes, please purchase the correct water faucet adapter to fit the supply hose.
- Page 21 [Connecting the drain hose] See detail after connect the drain hose Water and ice may leak over the drain. Installing the drain hose, lower than the drain (Picture on the left). Do not extend the length more than 1.0m. This can cause failure of drainage. Drain pipe is located in front side cover.
-
Page 22: How To Connect/Disconnect The
VAT (MILK CONTAINER) INSTALLS AND REMOVES [Install] First of all, push the silicone hose one end connect with deep pan, and other end insert on the hole. Make sure the deep pan whole stays in right rear side. Insert an about half of the protrusions. Makes it difficult to remove when insert too much. - Page 23 [Separation Method] Please prepare a container(x) before remove the Vat container from the machine and put it in bin storage. (1) - Please empty out the liquid from Vat container. - Remove silicone hose from the alignment pin. Turn Interval control disk (B) on Stop-Bar clock wise 2~3times and then turn Mounting bolt(C) Counter-clock wise.
-
Page 24: 24 Using Related Method
USING RELATED METHODS [Check before use] When the smell in the Super Snow machine ▶ Please follow the ‘cleaning method’, clean the machine and open the top and front acrylic door and let it dry ▶ Please remove tapes and any attachment causes odor First activation of Super Snow Machine ▶... - Page 25 [How to Use Super Snow Machine - Condenser] To improve the cooling efficiency... Please open the back side and both side of the machine, and clean thoroughly all over the surface (reference the photo on right). Use brush to remove the dirt from the condenser.
-
Page 26: Basic Function Of Button
BASIC KEY FUNCTIONS OF KEY [Prepare of operating] 1. Connect the power plug (power plugs are varies from country to country) to the outlet (recommend more than 20A) and turn on power switch located on the back/right side. 2. Use single power cord for super snow machine. Do not use the multi tap. 3. -
Page 27: Stainless Vat
[ Indicator and button functions] Touch Switch Number Indicator Lamp Method of operation Power Switch (located in the right or ▶ Indicated when power switch is on POWER back side of the super snow machine) 1st Touch: Machine is automatically selected on 'Flavor' and 'One' mode - the lamp indicated on: 'POWER', 1st Touch 'WATER', and 'ONE... -
Page 28: Stainless Vat
[How to activate the Super Snow Machine] 1. Activate and produce snow method (Use 'Select' button on the left) ⓐ Turn on the power switch located on the back side or right side of the machine. - 'STATUS' indicated with LED light. ⓑ... -
Page 29: How To Produce Snow Flakes
HOW TO PRODUCE SNOW FLAKE [Produce with WATER] 1. Turn on the power switch. 2. Use 'SELECT' button located on the left, select the mode to 'WATER' and press 'SELECT' button again. Select the amount mode of: single or continuously of snow. It takes about 30 seconds to freeze the drum. -
Page 30: Cleaning Method
CLEANING METHOD [Cleaning method] ※ The bacteria and fungi in the air, could grow with humidity during the humid summer or indoor pollution ※ You may see the changing color of water do to the not used long time pluming or water supply and aging plumbing connection. - Page 31 [How to clean Super Snow Machine] 3. Place a container in Bin 1. Press ‘POWER’ button to stop activating 2. Use kitchen-use plastic ice Storage to take remained the machine. Make sure check the compressor scoop to remove all the ice liquid from Vat container is completely stopped.
-
Page 32: Stainless Vat
10. Cleaning the sensor with 11. Double check the edge and side, make sure clean thoroughly with dish non-scratch scrub sponge. solution with baby bottle cleaning brush. Especially check the drum bolt part Just be careful while - use toothbrush to clean the bolt. cleaning. -
Page 33: Stainless Vat
[How to clean stainless vat] 1.Remove the stainless vat 2. Separate the silicone hose 3. Pre-rinse the stainless vat 4. Add 1 tbsp. (30ml) of dish detergent and 500ml of from the top (Remove the from stainless vat. and silicon hose with hot water (160-170˚F/71.1- silicone hose as well) -
Page 34: Cleaning Method
[How to clean 'Stop-bar'] 3ℓ 1.Remove the stop-bar 2. Use 5 liter sized bucket, 3. Add all the part on the 4. Pull out the part one-by- and part from the machine. add 3L of hot water dish solution for 5 minutes. one and scrub carefully with Pre-rinse the stop-bar and (160-170˚F/71.1-76.7˚C) and... -
Page 35: Troubleshooting
BEFORE REQUESTING REPAIR/SERVICE [Solution after Checking Mechanic Problem] The Phenomenon of water on the floor. ▶ Check if water supply or drain hose removed from the machine Hear ‘tok’ sounds in the machine (any noises come out from the machine ▶... - Page 36 Super Snow machine is not working ▶ Water supply is locked maybe? Please turn back on the water supply. ▶ Use the multi tap or extension code? The may result in fire due to the overheating of the power weakened. Please do not use the multi tap and extension code Machine is not operating even power is on ▶...
- Page 37 Rough grinding noise from the drum ▶ The remaining refrigerant gas cause the noise in drum (only apply to the freezing phenomenon during clean mode) ▶ The refrigerant operates as a completely discharged, please change back to water or flavor mode and operate little while and turn off the machine. When drum is stop, please turn back on the power, set as clean mode again and rotate the drum again by pushing flake button Note: the coolant remaining in the drum, can cause rough grinding noise...
-
Page 38: Other Info
OTHER INFORMATION ※ Waste Treatment of Product For the environmental protection purposes and recycling the waste electronic products should be handled properly [Processing Fee] If you like to discard without purchasing new product, please call your local community center or waste department to be discard your machine Notify the waste product and pay for the processing fee Community Center... -
Page 39: Specification
TECHNICAL SPECS Model SUF-200NW-CK Ice type Snow shaved/flavored snow ice Cooling Type Air Cooling Hydraulic Pressure 0.05~78 Mpa (0.5~8 Kgf/cm2) Weight 65Kg Capacity/Day 125kg/day Bin Capacity 6.0kg (41bw/200g) - 80min Dimension 392 x 507 x 811 mm 100-120V/60Hz, Single phase... - Page 40 NOTES...
- Page 41 CLEAN CONTROL TABLE Date Name Inspected by Check Memo * Cut and laminate this page. Place on the super snow machine for cleaning record.
- Page 42 Bars Korea Finest Ice Flake Machine Wonmigu, Jomaruro 403, 3F Gyeong-gido, Bucheon City, South Korea Tel: 032.581.3466 Fax: 032.581.8937 E-mail: barskorea@naver.com Web: www.icemakerplus.com Copyrightⓒ 2016 Bars Korea. All rights reserved Ver. 2.1...