Page 1
Part #950130-001 Product Manual: Model #6759 Work Umbrella ISO 90 01 Cert ified T.A. Pelsue Company 2500 South Tejon Street Englewood, Colorado, USA 80110 Tel. 800-525-8460 or 303-936-7432 Fax. 303-934-5581 Internet: www.pelsue.com Email: sales@pelsue.com...
Page 2
Page 2 #950130-001 - Product Manual: Model #6759 WORK UMBRELLA - Revision 00 - Date: 09-06-2016...
Page 3
Pelsue continues the dedication that industry throughout the world. has made us pre-eminent in this field. Page 3 #950130-001 - Product Manual: Model #6759 WORK UMBRELLA - Revision 00 - Date: 09-06-2016...
EVERY T.A. PELSUE COMPANY EMPLOYEE IS ExPECTED TO COMMIT TO THIS PHILOSOPHY IN THE PERFORMANCE OF HIS OR HER DAILY TASkS. QUALITY FIRST! T.A. PELSUE COMPANY SENIOR MANAGEMENT TEAM Page 5 #950130-001 - Product Manual: Model #6759 WORK UMBRELLA - Revision 00 - Date: 09-06-2016...
2.0 - Introduction & Product Information Congratulations on your choice of a Pelsue Model #6759 Work Umbrella to facilitate your remote location shelter requirements. This equipment has been designed and manufactured to meet the needs of the discriminating operator for efficiency and safety during operations which require protection from the weather. The Umbrella is designed as a shelter for technicians as well as equipment in outdoor or exposed locations.
3.0 - Configuration & Assembly Upon initial receipt of the Model #6759 Umbrella, inspect the packaging for any evidence that the product may have been damaged in shipment. While unpacking the product, inspect all of the components for damage. If damage to any of the components is discovered, Alert the shipping carrier immediately of the damage to the shipment.
Page 9
SPRING - SINGLE TURN, 4 WAVE, STAINLESS, GAP, 1.875 OD 100050-009 WASHER - FLAT, 1/4 IN, TYPE A, W, PLATED Table 3.1a: #6759 Parts List Page 9 #950130-001 - Product Manual: Model #6759 WORK UMBRELLA - Revision 00 - Date: 09-06-2016...
You are responsible for the safe operation of your Pelsue #6759 Work Umbrella. You must ensure that anyone who will operate or work around the shelter be familiar with the proper Safe Operating Procedure. This manual will take you step-by-step through the workings and capabilities of the #6759 Umbrella and alert you to good safety and operating practices while using the system.
5.0 - Product Operation The following section will address the capabilities and the general operation of the Pelsue Model #6759 Work Umbrella. The instructions contained within this section should be adhered to each and every time the product is used. Any person tasked with installing or operating this piece of equipment should be familiar with these procedures.
5.2 - Set-Up, Operating, & Take-Down Procedures Prior to Operation, the #6759 Work Umbrella should be configured and prepared according to the following guidelines. It is necessary to perform a visual inspection, each time, prior to using the product. If deficiencies are found, remove the product from service and contact the T.A.
Page 14
RELEASE NIB RELEASE NIB LOCATION LOCATION Figure #5.2b: Location of cup nibs for release of vacuum mount. Page 14 #950130-001 - Product Manual: Model #6759 WORK UMBRELLA - Revision 00 - Date: 09-06-2016...