TP-Link Archer C3150 Quick Installation Manual

Quick Installation Guide

AC3150 Wireless MU-MIMO Gigabit Router
C3150
Connect the Hardware
If your Internet connection is through an Ethernet cable from the wall
instead of through a DSL / Cable / Satellite modem, connect the Ethernet
cable directly to the router's Internet port, then follow steps 1, 5 and 6 to
complete the hardware connection.
Internet
Power adapter
2
3
Modem
4
1
Install the antennas.
Router
Turn off the modem, and
remove the backup battery
if it has one.
Connect the modem to the
Internet port on your router
with an Ethernet cable.
Turn on the modem, and
then wait about 2 minutes
for it to restart.
5
Connect the power
adapter to the router Power adapter
and turn on the router.
6
Verify that the following LEDs turn solid before
continuing with the configuration.
Power 2.4GHz 5GHz Internet
On On On On
Note: If the 2.4GHz LED and 5GHz LED are off, please press the
Wi-Fi On/Off button on the side panel for 2 seconds, then both
LEDs should turn stable in a few seconds.
For optimum performance, orient the four
antennas as shown in the drawing below.
30° 30°