Advertisement
Quick Links
X-CAM 2 Axis Gimbal Stabilization Module User Manual
There are 4 versions of this product available
2 Axis Stablizaton: GSM110, GSM210
3 Axis Stablizaton: GSM120, GSM220
Connection Direction
Specification：
Input Voltage： 5 – 7.2 V
Volume： 45 x 35 x 10 mm
Support PC software for setup
External GAIN adjustable
Does not support no potentiometer servos
Advertisement
Summary of Contents for X-cam GSM110
- Page 1 X-CAM 2 Axis Gimbal Stabilization Module User Manual Specification： Input Voltage： 5 – 7.2 V Volume： 45 x 35 x 10 mm Support PC software for setup External GAIN adjustable Does not support no potentiometer servos There are 4 versions of this product available...
- Page 2 Setup via Remote Controller How to use the Remote Controller for Servo Reverse Setup ： 1. Connect to channel CH5 on the Printed Circuit Board (PCB) 2. Push this channel to the highest position on your Remote Controller 3. There will be 3 BEEPs followed by the Red LED flashing, Return the Remote Controller Lever to the middle position to enter the Servo Reverse Setup mode 4.
- Page 3 Assemble the module Please notice there is an arrow on the PCB board, this is the forward direction This module can not be assembled on the camera mount, suggest assemble on the copter frame body. PC Software Connect with PC Uses the USB adapter to connect with your PC , Normally the Windows can find the driver automatically, you could find the PORT number in the device Manager...
-
Page 4: Gimbal Control
Launch the X-CAM Gimbal Stabilization Module Assistant , choose the correct port number and click CONNECT BEEP BEEP will be shouted after the connection succeed, the parameters will be read out automatically. The parameters as below: Gains There are 2 gains, Position Gain and Acceleration Gain Pos. - Page 5 Push speed: Setup the camera mount moving speed, high value set high speed; low value set low speed. Sensor Offset Do not set this value without the technical support from X-CAM Disclaimer Do not disassemble the X100B and the electronic components...