Whirlpool MH6140XKQ/B Manual page 25

7. Place your fingertips under the ends of the
ribbon cable connector locking rail and lift
the rail, then pull the end of the ribbon
cable out of the connector.
Locking
Rail
Ground Wire Screw
8. Remove the green ground wire screw
from the control panel.
9. Remove the two screws from the trans-
former bracket.
Transformer Bracket Screws
10. Press the locking tab and unlock it from
the end of the control board, then pull the
other end of the board out of the holder
slots, and remove the board.
3-5