Sunbeam KE8850R User Manual

Need help with your appliance?
Contact our customer service team or visit our website
for information and tips on getting the most from your appliance.
Australia New Zealand
Phone 1300 881 861 Phone 0800 786 232
Mail Level 6, Building 5, Central Park,
Mail Units 5 & 6, 13 Lord Street,
660-670 Great South Road,
Botany NSW 2019 Australia
Greenlane, Auckland
Visit www.sunbeam.com.au
New Zealand
Visit www.sunbeam.co.nz
Sunbeam Corporation Limited | ABN 45 000 006 771
Sunbeam Corporation is a division of GUD Holdings Limited.
Sunbeam is a registered trademark. Made in China to Sunbeam's specification.
Due to minor changes in design or otherwise, the product you buy may differ slightly from the one
shown here. Approved by the appropriate electrical regulatory authorities.
©Copyright Sunbeam 2015.
3011A
3011-A-IB.indd 1
Care and Cleaning
Always disconnect the kettle from the power abrasive cleaners to clean the outside of the
outlet before cleaning. kettle, as these will scratch the stainless steel
surface.
Never immerse the kettle switch area, cord
or power base in water, or allow moisture to
To clean the mesh filter.
come into contact with these parts.
Open the lid. Grasp the top of the mesh
filter and pull upwards to remove. Wash in
Descale Your Kettle Regularly.
warm soapy water and dry thoroughly before
Mineral deposits in tap water solidify when
replacing in the kettle.
the water is heated; lime scale may be white,
coloured, even rusty-looking and is normally
visible but phosphate scale isn't generally Cleaning the concealed heating element
This kettle features a non-corrosive stainless
visible although may cause the water to
steel heating element. Over time, scale may
appear cloudy when heated. This may cause
the interior of the water gauge to discolour, build up on the concealed element inside
cause overheating, trigger the boil-dry cut-out the kettle, causing discolouration that may
have the appearance of rust. Be assured this
mechanism or even reduce the kettle's life.
is not rust. If this occurs clean with a green
Even in soft water areas it is important to
Scotchbrite ® scourer or similar and a suitable
descale your kettle regularly to help maintains
abrasive cleaning cream. Rinse and clean
its lifecycle.
thoroughly with tap water before using your
kettle again.
NOTE: Failure to descale products regularly
can be deemed as negligent handling and any
faults caused by mineral build up will not be
covered by the Sunbeam 12 Month Guarantee.
To remove this build-up, use Sunbeam
Liquid Descaler, a simple to use, non-toxic
cleaner available from Sunbeam Appointed
Service Agents.
Alternatively:
1. Fill the kettle with 3 cups of white vinegar
and the remainder with water and allow to
stand overnight. DO NOT BOIL.
2. Empty the solution from the kettle. Any
stains remaining inside the spout can be
removed by rubbing with a damp cloth. Fill
the kettle with clean water, bring to boil
and then discard the water. Repeat and the
kettle will then be ready to use.
To clean the stainless exterior
The kettle surface may be wiped over with a
damp cloth and polished with a soft dry cloth.
CAUTION: Do not use chemicals, steelwool, or
6
12 Month Replacement Guarantee
Upon receipt of your claim, Sunbeam will seek to The benefits given to you by our warranty are in
resolve your difficulties or, if the product is defective, addition to other rights and remedies under law
advise you on how to obtain a replacement or refund.
in relation to the product.
To assist us in managing warranty claims, we In Australia our goods come with guarantees that
recommend you register your product as soon as cannot be excluded under the Australian Consumer
practicable after purchase by creating a MySunbeam Law. You are entitled to a replacement or refund for
account on our website and uploading a copy of your a major failure and for compensation for any other
original receipt. foreseeable loss or damage. You are also entitled to
have the goods repaired or replaced if the goods fail
In order to make a claim under our warranty, you must to be of acceptable quality and the failure does not
have the original proof of purchase documentation amount to a major failure.
for the product and present it when requested (if not
already uploaded to our website). Our goods also come with guarantees that cannot
be excluded under the New Zealand Consumer
Should your product develop any defect within 12 Guarantees Act.
months of purchase because of faulty materials
or workmanship, we will replace or repair it, at our If your warranty claim is not accepted, we will inform
discretion, free of charge. A product presented for you and if requested to do so by you, repair the
repair may be replaced by a refurbished product of product provided you pay the usual charges for such
the same type rather than being repaired. Refurbished repair. You will also be responsible for all freight and
parts may be used to repair the product. other costs.
Our replacement or repair warranty only applies Should your product require repair or service after
where a defect arises as a result of faulty material the warranty period, contact your nearest Sunbeam
or workmanship during the warranty period. Your service centre.For a complete list of Sunbeam's
warranty does not cover misuse or negligent handling service centres, visit our website or call our customer
(including damage caused by failing to use the
service line for advice on 1300 881 861 in Australia,
product in accordance with this instruction booklet), or 0800 786 232 in New Zealand.
accidental damage, or normal wear and tear.
Your warranty does not:
• cover freight or any other costs incurred in making
a claim, consumable items, accessories that by their
Should you experience any difficulties with
nature and limited lifespan require periodic renewal
your product during the warranty period,
(such as filters and seals) or any consequential loss please contact our customer service line
or damage; or
for advice on 1300 881 861 in Australia, or
0800 786 232 in New Zealand.
• cover damage caused by:
- power surges, power dips, voltage supply
Australia | www.sunbeam.com.au
problems, or use of the product on
1300 881 861
incorrect voltage;
Units 5 & 6,
- servicing or modification of the product other
13 Lord Street,
than by Sunbeam or an authorised Sunbeam
Botany NSW 2019
service centre;
Australia
- use of the product with other accessories,
attachments, product supplies, parts or devices New Zealand | www.sunbeam.co.nz
that do not conform to Sunbeam specifications; or
0800 786 232
- exposure of the product to abnormally corrosive
Level 6, Building 5, Central Park,
conditions; or 660-670 Great South Road,
Greenlane, Auckland
• extend beyond 3 months if the product is
New Zealand
used in commercial, industrial, educational or
rental applications.
7
Kettle User Guide
Sunbeam's safety precautions 2
Sunbeam's 3-way safety system 3
Features of your kettle 4
Using your kettle 5
Care and cleaning 6
KE8850R | KE8850W | KE8850K | KE8850B | KE8850G | KE8850O | KE8850Y
26/08/2015 3:26:47 PM