Connection: Tv/Vcr + Satellite Receiver - RCA TruFlat T20TF668 User Manual

Connections & Setup
10
TV/VCR back panel
ANT/CABLE
75
1A
Satellite receiver
back panel
OUT
VIDEO L

Connection: TV/VCR + Satellite Receiver

1. Connect the satellite receiver to the TV/VCR
A. Connect one end of an RF coaxial cable (not included) to the TV/VCR's
ANT/CABLE jack. Connect the other end to the satellite receiver's antenna output
jack (sometimes labeled OUT TO TV).
B. Connect the A/V cables. Connect audio cables to the TV/VCR's LINE IN/IN 1
AUDIO (L and R) jacks and the other ends to the satellite receiver's corresponding
audio output jacks. Connect one end of the video cable to the TV/VCR's LINE IN/
IN 1 VIDEO jack, and the other end to the satellite receiver/cable box's video
output jack.
2. Connect antenna or cable to your satellite receiver
Connect the coaxial cable from your antenna, cable feed, or cable box to the Antenna
Input jack on the satellite receiver (sometimes labeled IN FROM ANT).
3. If necessary, connect the satellite's antenna cable to the satellite receiver
If the coaxial cable from the satellite dish antenna isn't already connected to the
satellite receiver's input jack (sometimes labeled SATELLITE IN), connect it now.
LINE IN LINE COMPONENT-IN
IN 1 OUT
AUDIO VIDEO
Y
VIDEO
P
L L
(C
AUDIO
P
R R
(C
1B
IN FROM ANT
OUT TO TV
SATELLITE
IN
R
S-VIDEO
2
From Antenna/Cable Feed
Note: If you have model
T27TF668, the placement
of the jacks is different
from the TV/VCR back
panel illustrated here.
B
)
B
R
)
R
Note: The back of
CH3
your satellite receiver
CH4
might not look
exactly like the one
3
shown here.
From
Satellite
Go To Page 11
Chapter 1