Locking Safe / Unlocking Safe - Honeywell 5103S-5107S Operations & Installation Manual

LOCKING SAFE
The lock design allows for a new user code each time that the safe is locked
1. Enter any 3-6 digit Pass Code, for example "1"-"5"–"9" (Figure 1).
2. Immediately after entering the code, press the "LOCK" key (Figure 2).
3. Lock bolts should extend into the locked position (Figure 3).
4. The LED will display
(Figure 4 & 5).
Figure 1
PRIVACY MODE: To prevent the LED displaying the pass code entered, press "CLEAR" prior to
entering a code.
LOCK SOUND: To turn "beep" sound On or Off, press the "CLEAR" button twice.
UNLOCKING SAFE
1. To open safe enter the new pass code that was used to lock the safe in Step 1 of the
"LOCKING SAFE" section above (Figure 1).
2. Immediately after entering the code, press the "LOCK" key (Figure 2).
3. Lock bolts should receed into the unlocked position (Figure 3).
4. The LED will display
bottom of the keypad (Figure 4).
Figure 1
NOTE: You can relock the safe by entering any 3-6 digit Pass Code followed by the "LOCK" key
for 3 seconds followed by the active code entered as a reminder.
Figure 2 Figure 3
and you can then pull door open using the handle located at the
Figure 2
Figure 4
Figure 3 Figure 4
Figure 5
3