Output select ............8 The MF-2 contains a lithium battery. To avoid explosion do not expose the battery to extremes Selecting MIDI program changes .
Page 3
In the SETUP mode you can adjust values for the overall (=global) functions. before. We've made sure that each MF-2 is set up in the factory for immediate use, so if you are anxious to begin using your new unit straight away, GO AHEAD! When you need to know The functions of the EDIT mode are left next the corresponding footswitch printed in bold letters.
Page 4
Footswitches (numbered 1-9, 0) MIDI In/Out jacks UP/DOWN footswitches Power supply jack (9~12V DC/0.5A) LED indicators for Switches 1-4 (10) Power switch (ON/OFF/PHANTOM) (11) Expression pedal outputs 1-4 4 4 4 4 4 Owners Manual - MIDI Foot Controller MF-2...
= Sends nothing! Start = Sends MIDI START (Sequencer, Drummachine) The MF-2 has four different steps of brightness for the display. You will waiste less energy if you choose Stop = Sends MIDI STOP (Sequencer, Drummachine) the darkest step. The "automatic": If you activate the automatic the MF-2 will be switched to the darkest...
Page 6
BACKUP POWER Shows the actual software version number. The MF-2 uses an internal lithium battery to hold the internal data (memory) during power off. The life FACTORY SETUP is approx. 5~7 years. The MF-2 permanently checks it state. If the backup battery is down, the middle Warning - Overwrites internal data.
Page 7
You can choose between two different modes to use the MF-2 as a MIDI footcontroller: The BANK mode or the DIRECT mode. Normally the MF-2 is right now ready to work. No further settings are neccessary to use it as a standard BANK MODE MIDI footcontroller: The bank mode should be used to change between programs with a single step on a footswitch 0-9.
MEMORY PROTECTION OUTPUT SELECT To protect the internal memory of the MF-2 against overwriting you can set the MEMORY PROTECT An OUTPUT refers to a MIDI TRANSMIT CHANNEL selected in the SETUP mode. Unused OUTPUTS switch (7) (located on the back) to "ON".
MIDI VOLUME will be changed from the actual saved MIDI VOLUME down to 0 or internal relays is not connected to the other nor to the MF-2. This prevents problems with humnoise. from 0 up to the actual saved MIDI VOLUME. The fadetime is adjustable from 0.1 ~ 9.9 seconds.
ECONOMY CONFIGURATION The MF-2 is able to send on all 16 MIDI TRANSMIT CHANNELS simultaneously. If you need less you The brightness of the DISPLAY is adjustable in four steps! 1 = bright; 2..4 = less bright . A switchable better deactivate unused MIDI TRANSMIT CHANNELS in the SETUP.
Cu9 = C , backward Enter the requested CONTROLLER NUMBER with the footswitches 0..9, UP, DOWN. Press the ENTER key. Controller Value Changes of the SETUP are saved after pressing the ENTER key! Owners Manual - MIDI Foot Controller MF-2...
The (just for fun) built in function of the FUNNY NOTE MODE in our previous model MF-1 was really a success! Thanks to all! Therefore we have it in the MF-2 too! The FUNNY NOTE MODE enables you Connect to an external device to sends 12 MIDI notes (C~Bb;...
8 SPECIAL FUNCTIONS FACTORY SETUP LISTS LIST OF THE LOACAL CONFIGURATION You can restore all or some parts (local, global) of the MF-2 to the factory defaults. (Initialize) INITIALIZE (FACTORY SETUP) OUTPUT 1..16: MIDI PROGRAM CHANGE = 1..128 (True MIDI= 0..127)
Need help?
Do you have a question about the MF-2 and is the answer not in the manual?
Questions and answers