Ruby Electronics GrabBee-HD User Manual

Hdmi 1080p usb grabber

Advertisement

Quick Links

GrabBee-HD
HDMI 1080P USB Grabber
FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15 of the FCC Rules Operation is subject to the following two conditions:
this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiated radio
frequency energy and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communication. However, there is no grantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by tuning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Notice: Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
CE DECLARATION
This device complies with CE . These limits are designed to provide reasonable protection against
harmful interface in a residential installation.
Printed in TAIWAN R.O.C No. 20131009
All contents are subject to change without notice.
All trademarks are the property of their respective owner.
User's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GrabBee-HD and is the answer not in the manual?

Questions and answers

Summary of Contents for Ruby Electronics GrabBee-HD

  • Page 1 (2) this device must accept any interference received, including interference that may cause undesired operation. GrabBee-HD This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of the FCC Rules.
  • Page 2: Table Of Contents

    It is the bridge between your computer and Full HD video 1.4 System Requirements......................source. 1.5 Package Contents........................GrabBee-HD is small enough to fit in the palm of your hand and it is ideal for both notebook and 1.6 Hardware device description………………………………………………………………………… desktop computers. CHAPTER 2. INSTALLATION......................
  • Page 3: Chapter 1. Overview | 2

    CHAPTER 1. OVERVIEW | 2 CHAPTER 2. INSTALLATION | 3 ※ Do not connect GrabBee-HD to computer USB port before driver installation 1.4 System Requirements ※ Please follow the steps to install Driver and Software USB 2.0 equipped computer •...
  • Page 4: Install Application Software

    2.2.4 Check accept the terms in the license 2.3.3 Complete Setup Wizard, agreement and click “Agree” Click "Finish" to restart computer now 2.2.5 Click “Next” to install DivX+ software 2.3.4 After restart computer, you will see the GrabBee-HD icon on desktop.
  • Page 5: Plug In Grabbee-Hd Hardware

    CHAPTER 2. INSTALLATION | 6 CHAPTER 3. OPERATION | 7 2.4 Plug in GrabBee-HD hardware 3.1 Starting * Please follow the steps to plug in GrabBee-HD hardware, or system may not detect the Please click the GrabBee-HD icon on desktop. GrabBee-HD device successfully.
  • Page 6: Software Configuration

    3.4.2 File • Disk Reserved: Check and Set the Disk Reserved GrabBee-HD Software will pop up Software Configuration window, please select your • Enable Capture Time Limit: Check and Set the Enable Capture Time Limit Video Format / Language / Video from drop down menu., then click “OK”...
  • Page 7: Grabbee-Hd

    1. Video Screen: Video preview window 2. Toggle Mode: Reconnect / Refresh the Video Screen. - Start Menu -> GrabBee-HD -> GrabBee-HD HW Config -> Go to Hardware Configuration. See 3.2 3. Top Most: GrabBee-HD control panel and video screen always on top.
  • Page 8 Q3 : Why can’t my system detect the GrabBee-HD? A1 : If you are having a problem with GrabBee-HD does not working, you should connect GrabBee-HD A3 : (a) Please make sure the GrabBee-HD hardware plug in steps is correct.
  • Page 9 CHAPTER 4. TROUBLESHOOTING | 14 Q5: How can I close UAC (Users Account Control) message when start GrabBee-HD software? A5 : When the first time start GrabBee-HD software, system will pop up UAC (Users Account Control) message, please click “Yes” to continue.

Table of Contents