Advertisement
The JUWEL filter system Bioflow
The JUWEL filter system Bioflow is a highly effective biological filter system with two
stages that includes components complementing each other in an ideal manner.
Installing the filter in the aquarium makes hose connections unnecessary and prevents
leaks. The pump output is not negatively affected by hose couplings, intake tubes etc.
The capacity of the pump is designed in such a manner that an ideal level of biological
filtering is ensured by a sufficient level of percolation through the filter material.
In that context, the large filter volume ensures excellent mechanical filtering and
facilitates long cleaning intervals.
The construction of the filter system enables you to quickly access the individual
heater, pump, and filter media components. This way, the filter system may
comfortably be operated during cleaning and while performing maintenance work.
bioPad - Pre-Filter Wool Pad (white)
The white filter wool acts as a mechanical pre-filter, removing large particles of dirt
and excess food which in turn ensures that the other sponges do not get clogged.
bioCarb - Active Carbon Sponge (black)
The black activated carbon sponge sits on top of the blue coarse filter sponges, and
removes chemical impurities from the water, which cannot be removed biologically.
Nitrax - Nitrate Removal Sponge (green)
The Sponge contains micro-organisms, which will, once developed, reside inside the
sponges and in the water. These micro-organisms feed of nitrates and will reduce them
significantly. The JUWEL Filtration system provides the optimum housing for these
micro-organisms.
bioPlus fine - Filter Sponge Fine (blue)
The fine blue sponge and the bacteria cultures living in them, clean the water of even
the smallest impurities. As the sponge has a very fine structure the water will flow
through it even slower, allowing the bacteria even more time to perform their
function.
Installation of the JUWEL Filter System in your Aquarium
The JUWEL Filter has been designed for installation in the right hand corner of the
aquarium.
First of all, please remove all internal components of the Filter System leaving you
with the empty filter housing.
In order to ensure that the Filter System is securely fastened to the glass panels, we
have included a tube of special JUWEL Aquarium silicon. Apply the silicone onto the
housing as shown in the picture, on both the side and the rear walls.
Your Aquarium should be empty or as near as empty, allowing you to wipe the glass
dry.
Position the filter housing in the aquarium in such a way that the top of the filter
housing rises 1 cm above the maximum water level of your aquarium.
Press the housing onto the glass panels firmly, and hold it for a few minutes. Allow
the silicone to dry out for at least 24 hours.
Bioflow Super
Bioflow 3.0
Bioflow 6.0
Bioflow 8.0
3
Advertisement
