After Each Use - Eagle power FASTRACTS SC12 Operation And Parts Manual

NOTE: If dirty solution does not appear through the vacuum lid check to be sure if:
•
The vacuum lid is resting properly on the recovery pails
•
The machine's nose is touching the carpet in the working mode.
•
The solution tank is not empty.
4. Roll the machine forward on its four wheels for next stroke. Make overlapping passes to prevent
streaking. Check solution level from time to time (see solution indicator tube on rear left corner of
the back).
NOTE: If foam appears on vacuum lid, turn the VACUUM SWITCH OFF IMMEDIATELY. Add more
defoamer to the recovery pails to dissolve foam or empty the recovery pails.
5. When the solution tank runs empty, turn off the vacuum, pump and brush switches. Empty the
recovery pail and rinse thoroughly. Then repeat steps on PREPARING THE MACHINE.
TO ATTACH ACCESSORY HOSE
1. Remove 2" hose adapter connection from machine.
2. Attach 1 1/2" assembly with adapter plate to vacuum lid inlet.
3. Pull back female quick disconnect sleeve on the machine and insert male plug on the solution
hose.
Attach 1-1/2" assembly
TO EMPTY THE SOLUTION TANK
1. Unhook the drain nozzle (located on the side of the machine from the drain clips), placing the
end of the hose into the recovery pail.

AFTER EACH USE

•
Empty and thoroughly rinse the recovery pail.
• Coil power cord onto the cord wrap.
•
Remove dirt and lint build-up inside vacuum lid filter screen.
•
Clean solution line filter.
•
Wash the vacuum lid with a soap solution and sponge to prevent dirt from accumulating on
the surface. (To avoid scratching use soft cloth only).
•
Lean the machine back on its 4 wheels during storage or when it's not in use to prevent
brush distortion.)
Remove 2" hose adapter