SkyBean User Manual

SKYBEAN USER MANUAL
POWER
1
GREEN AND RED
LED INDICATOR
2
PUSH
MENU
2
2x
READY
CLICK
5
sec.
VOLUME
3
FLASHING
CLICK
5
READY
LIFT TRESHOLD
4
G R
PUSH
CLICK
READY
FLASHING
SINK TRESHOLD
5
G
R
PUSH
PUSH
READY
FLASHING
ON
- -
ON OFF
G
R
sec.
G R
G R
FLASHING
MENU
2x
1x
G
R
4x
sec.
1x = 0.1m/s
G R
2x = 0.2m/s
3x = 0.3m/s
4x = 0.4m/s
5x = 0.5m/s
CLICK
5
sec.
1x = OFF
2x = -0.5m/s
G
R
3x = -1.0m/s
4x = -1.5m/s
5x = -2.0m/s
6x = -2.5m/s
7x = -3.0m/s
8x = -3.5m/s
CLICK
5
sec.
1. SWITCHING ON /OFF - VERY LONG KEY PRESS (ABOUT 2 SECONDS)
2. GET INTO MENU BY DOUBLE-CLICK - LED SIGNALIZATION STARS FLASHING ( LAST
ABOUT 5
SECONDS, THEN YOU'LL GET BACK TO "READY" STATUS
3. ADJUST THE VOLUME SIGNALLING - FROM MENU (LED SIGNALIZATION FLASHING) -
SHORT PRESS ADJUSTS / SWITCHES BETWEEN FOUR VOLUME LEVELS. VARIO FLASHES AND
BEEPS EACH TIME YOU PRESS THE BUTTON. VOLUME LEVEL DEPENDS ON NUMBER OF
PRESSES.
4. SET THE SPEED LIMIT DURING THE CLIMB – FROM MENU (LED SIGNALIZATION
FLASHING) - LONG PRESS (0.5 SECONDS) AND SUBSEQUENT SHORT PRESSES (GREEN
LIGHT FLASHES, AN UPWARD TONE IS PLAYED AND VARIO BEEPS AND FLASHES RE-
PEATEDLY DEPENDING ON SET LEVEL) USE A SHORT PRESS TO SET THE SPEED LIMIT:
5. SET THE SPEED LIMIT DURING DESCENT - FROM MENU (LED SIGNALIZATION
FLASHING) - TWO LONG PRESSES (2 X 0.5 SECONDS, RED LIGHT FLASHES, DECREAS-
ING TONE IS PLAYED AND VARIO BEEPS AND FLASHES REPEATEDLY DEPENDING ON
SET LEVEL) USE A SHORT PRESS TO SET THE SPEED LIMIT:
SKYBEAN BEEPS 1X = OFF
OFF
SKYBEAN BEEPS 2X = 0,5 m/s
SKYBEAN BEEPS 3X = 1,0 m/s
SKYBEAN BEEPS 4X = 1,5 m/s
R
G

VARIO DISASSEMBLY

3
4
5
3x

BATTERY REPLACEMENT

SKYBEAN BEEPS 1X = 0,1 m/s
SKYBEAN BEEPS 2X = 0,2 m/s
SKYBEAN BEEPS 3X = 0,3 m/s
SKYBEAN BEEPS 4X = 0,4 m/s
SKYBEAN BEEPS 5X = 0,5 m/s
SKYBEAN BEEPS 5X = 2,0 m/s
SKYBEAN BEEPS 6X = 2,5 m/s
SKYBEAN BEEPS 7X = 3,0 m/s
SKYBEAN BEEPS 8X = 3,5 m/s
PH1
THIS("+") SIDE UP!