Wirepath WP-MOD-COMBOVT Installation Manual

TROUBLESHOOTING
Wirepath structured wire modules are designed to function trouble-free. Most problems that
occur are due to simple issues. If you have trouble, please check the list of simple fixes
below. If the problem persists, contact your authorized Wirepath dealer or Wirepath customer
service at 866.424.4489.
No Video output or picture on outputs
• Power supply is connected incorrectly or plugged into an outlet that does not have power.
Check connections and verify power on the outlet. The red LED on module will be lit when
power is correctly connected.
• Verify that there is signal on any of the inputs being used.
• Check all wiring connections on output(s) with no signal including any wall-plate
connections at the remote location.
No Telephone signal
• Verify that there is signal on the input being used.
• Check all wiring connections on output(s) with no signal including any wall-plate
connections at the remote location.
• Disconnect RJ-31X cable if this option is being used. Retry operation.
Two-Year Warranty
All Wirepath products have a two-year Limited Warranty. This
®
warranty includes parts and labor repairs on all components
found to be defective in material or workmanship under normal
conditions of use. This warranty shall not apply to products which
have been abused, modified or disassembled. Products to be
repaired under this warranty must be returned to the SnapAV or a
designated service center with prior notification and an assigned
return authorization number (RA).
®
wirepath
10405 Granite Street
charlotte, Nc 28273
704.927.7607
Tech Support: 1.866.424.4489
email: techsupport@snapav.com
www.snapav.com
©2007 Snap AV • Charlotte, NC
INSTALLATION GUIDE
2x6 POwERED RF VIDEO cOmBINED wITH 1x6 TELEPHONE SEcTION
2
2/3
4
®
>>wP-mOD-cOmBOVT
INTRODUcTION & FEATURES
INSTALLATION
SPEcIFIcATIONS