Table of Contents
Advertisement
Model MMC200 MULTI-MATERIAL CUTTER
Do not modify the plug provided – if it will not fit the
outlet, have the proper outlet installed by a quali-
fied electrician.
Improper connection of the equipment-grounding
conductor can result in a risk of electric shock.
The green conductor with or without yellow stripes
is the equipment-grounding conductor. If repair or
replacement of the electric cord or plug is neces-
sary, do not connect the equipment-grounding con-
ductor to a live terminal.
Check with a qualified electrician or service per-
sonnel if the grounding instructions are not com-
pletely understood, or if in doubt as to whether the
tool is properly grounded.
Use only 3-wire extension cords that have 3-prong
grounding plugs and 3-pole receptacles that ac-
cept the tool's plug. Repair or replace damaged or
worn cord immediately.
GENERAL INSTRUCTIONS
REMOVE ADJUSTING KEYS AND WRENCHES.
Form habit of checking to see that keys and ad-
justing wrenches are removed from tool before
turning on.
KEEP WORK AREA CLEAN. Cluttered areas and
benches invite accidents.
DON'T USE IN DANGEROUS ENVIRON-
MENTS. Don't use power tools in damp or wet
locations, or expose them to rain. Keep work area
well lighted.
ALWAYS USE SAFETY GLASSES. Everyday eye-
glasses only
have impact resistant lenses; they are NOT safety
glasses. Also use face or dust mask if cutting op-
eration is dusty.
WEAR PROPER APPAREL. Do not wear loose
clothing, gloves, neckties, rings, bracelets, or other
jewelry that might get caught in moving parts. Non-
slip footwear is recommended. Wear protective
hair covering to contain long hair.
Production Automation • Eden Prairie, MN USA • Ph: 888-903-0333 • info@gotopac.com • www.gotopac.com • Fax 952-903-0315
DON'T OVERREACH. Keep proper footing and
balance at all times.
MAINTAIN TOOLS WITH CARE. Keep tools
sharp and clean for best performance and to re-
duce the risk of injury. Follow instructions for lubri-
cating and changing accessories.
DISCONNECT TOOL before servicing; when
changing accessories, such as blades, wheels,
cutters, and like.
USE RECOMMENDED ACCESSORIES. Consult
the operating manual for recommended accesso-
ries. The use of improper accessories may cause
risk of injury to persons.
CHECK DAMAGED PARTS. Before further use
of the tool, a guard or other part that is damaged
should be carefully checked to determine that it
will operate properly and perform its intended func-
tion. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mounting, and
any other conditions that may affect its operation.
A guard or other part that is damaged should be
properly repaired or replaced.
DO NOT EXCEED THE MAXIMUM MATERIAL
SPECIFICATIONS.
DO
NOT
OPERATED
GUARDS IN PLACE OR GUARDS NOT IN
WORKING ORDER.
DO NOT PERFORM MAINTENANCE OR
ADJUSTMENTS WITH POWER ON.
DO NOT PLACE FINGERS OR APPENDAGES
IN OR NEAR OPENINGS IN GUARDS.
DO NOT RUN UNIT WITH INCORRECT LINE
VOLTAGE. REFER TO LABEL PLACED TO THE
RIGHT OF THE IEC CONNECTOR.
DO NOT ALLOW UNTRAINED OR UNQUALI-
FIED PERSONNEL TO OPERATE UNIT.
DO NOT DEFEAT ANY OF THE SAFETY
FEATURES.
UNIT
WITHOUT
Advertisement
Table of Contents
