Table of Contents
Advertisement
Quick Links
INSTALLATION &
OPERATION MANUAL
HMD SERIES
HumidiHeat™
HOLDING & TRANSPORT
CABINETS
MODELS:
1826-5-HMD
1826-13-HMD
1826-15-HMD
For additional information on Wittco or to locate an authorized parts
and service provider in your area, visit our website at
www.wittco.com
WITTCO FOODSERVICE EQUIPMENT
7737 NORTH 81 STREET
MILWAUKEE, WI 53223
DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC.
www.wittco.com
©2009 Wittco Foodservice Equipment
F-41142 (10-09)
Advertisement
Table of Contents
Summary of Contents for Wittco 1826-13-HMD
-
Page 1: Operation Manual
HOLDING & TRANSPORT CABINETS MODELS: 1826-5-HMD 1826-13-HMD 1826-15-HMD For additional information on Wittco or to locate an authorized parts and service provider in your area, visit our website at www.wittco.com WITTCO FOODSERVICE EQUIPMENT 7737 NORTH 81 STREET MILWAUKEE, WI 53223 DIVISION OF ITW FOOD EQUIPMENT GROUP, LLC. -
Page 2: Important For Your Safety
HMD SERIES F-41142 (10-09) IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRICAL EQUIPMENT, WHO SHOULD PERFORM THE INITIAL FIELD START- UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITYOF THIS OR ANY OTHER APPLIANCE. -
Page 3: Table Of Contents
HMD SERIES F-41142 (10-09) TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY ........1 GENERAL . -
Page 4: General
Remove cardboard element agree, do not proceed with unpacking cover protector from cabinet and installation. Contact your Wittco bottom. Customer Service Department immediately. (Fig. 1) Remove adjustable tray slides from box. Remove the tray slide supports and install them in the cabinet. -
Page 5: Electrical Requirements
HMD SERIES F-41142 (10-09) Install tray slides in the cabinet. ELECTRICAL REQUIREMENTS Ensure that the hook on the end ELECTRICAL CODES & STANDARDS: of the tray slide is up. cabinet must installed accordance with: CLEANING: The cabinet should be thoroughly In the United States of America: cleaned prior to putting into service. -
Page 6: Lockout / Tagout Procedure
HMD SERIES F-41142 (10-09) receptacle proper grounding type, contact electrician. DO NOT REMOVE THE GROUNDING PRONG FROM THIS PLUG. Verify that the power source matches the Serial Data Plate located on the lower back corner of cabinet plug configuration before the connection is made. -
Page 7: Operation
HMD SERIES F-41142 (10-09) OPERATION the temperature. Holding temperature CONTROLS range is from 80⁰F. to 200⁰F. OPERATING INSTRUCTIONS Connect to proper electrical supply as indicated on data plate. Fill water into Water Reservoir. (Reservoir holds approx. 1 gallon or 3.78 liters of water.) The water level can be observed through the sight glass. -
Page 8: Shut Down
HMD SERIES F-41142 (10-09) As humidity is increasing to the CLEANING desired setting, the Humidity Control Sensor Light will be lit RED. When Always UNPLUG desired humidity been ELECTRICAL POWER SUPPLY reached, the light will change to before cleaning. GREEN. DAILY: NOTE: Unplug electrical power supply. -
Page 9: Stainless Steel Care
HMD SERIES F-41142 (10-09) HEAVY-DUTY CLEANING: Never rub in a circular motion. For heavy-duty cleaning, use warm Always rub gently in the direction water, a degreaser, and a plastic, of the steel grain. stainless steel, or Scotch-Brite pad. Never rub in a circular motion -- rub Never leave any food products gently in the direction of the steel grain. -
Page 10: Troubleshooting
Glass. Fill water in water reservoir. SERVICE & PARTS INFORMATION To obtain Service and Parts information concerning this model, contact Wittco Service Department at the address listed on the front cover of this manual or refer to our website: www.wittco.com... -
Page 11: Specifications
MODEL No. IN (mm) IN (mm) (mm) VOLTS WATTS AMPS Lb. (kg) 170# 32.375" 34.25" 25.125 (77kg) 1200 1826-5-HMD 340# 59.375" 34.25" 25.125" (154kg) 1200 1826-13-HMD (1700mm) (857mm) (724mm) 65" 370# (1702 34.25" 25" (167kg) 1200 1826-15-HMD (857mm) (724mm) NOTES:... -
Page 12: Wiring Diagram
HMD SERIES F-41142 (10-09) WIRING DIAGRAM...
Need help?
Do you have a question about the 1826-13-HMD and is the answer not in the manual?
Questions and answers