LG LFXS30726 series Owner's Manual page 50

50 MAINTENANCE
Application Guidelines/Water Supply
Parameters
Service Flow
Community or Private Well -
Water Supply
Water Pressure 20 – 120 psi (140 – 830 kPa)
36 °F – 100 °F (0.6 °C – 37.8
Water Temperature
Capacity 200 gallons (757 liters)
It is essential that the manufacturer's recommended
requirements be carried out for the product to perform
as advertised.
NOTE
While the testing was performed under standard
laboratory conditions, actual performance may vary.
Replacement Cartridge: ADQ36006101
lg.com website.
For further assistance, the LG Electronics Customer
Information Center is open 24 hours a day/7 days a
week.
USA: 1-800-243-0000
Canada: 1-888-542-2623
3M is a trademark of 3M Company.
NSF is a trademark of NSF International. © 2009 3M
Company. All rights reserved
Manufactured for LG ® Electronics by:
CUNO Incorporated, a 3M Company 400 Research
Parkway Meriden, CT 06450 U.S.A.
Telephone: 203-237-5541
Fax: 203-238-8701
WARNING
To reduce the risk associated with choking:
Do not allow children under 3 years of age to
have access to small parts during the installation
of this product.
To reduce the risk associated with the
ingestion of contaminants:
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
cysts. EPA Establishment # 070595-MEX-001
0.5 gpm (1.89 lpm)
Potable Water
°C)
CAUTION
To reduce the risk associated with property
damage due to water leakage:
Read and follow Use Instructions before
installation and use of this system.
Installation and use MUST comply with all state
and local plumbing codes.
Do not install if water pressure exceeds 120 psi
(827 kPa). If your water pressure exceeds 80
psi, you must install a pressure limiting valve.
Contact a plumbing uncertain how to check your
water pressure.
Do not install where water hammer conditions
may occur. If water hammer conditions exist you
must install a water hammer arrester. Contact a
plumbing professional if you are uncertain how to
check for this condition.
Do not install on hot water supply lines. The
maximum operating water temperature of this
temperatures drop below 40 °F (4.4 °C).
every 6 months, at the rated capacity or if a
when temperatures are expected to drop below
33° F.
Do not install systems in areas where ambient
temperatures may go above 110° F (43.3° C).
on a water system, a device for controlling
pressure due to thermal expansion must be
installed.
of leaks.