Table of Contents
Advertisement
If you forget to drain the water tank, the
machine will stop during the subsequent drying
cycles when the water tank is full and the Water
Tank warning symbol will flash. If this is the
case, drain the water tank and press Start /
Pause button to resume the drying cycle.
To drain the water tank:
1.
Remove the water tank in the drawer
or container carefully.
2.
Drain the water in the tank.
•
If there is lint accumulation in the funnel
of the water tank, clean it under running
water.
•
Place the water tank into its seat.
C
NOTE
•
If the direct water draining is used as an
option, there is no need to empty the
water tank.
6.4 Cleaning the filter drawer
Lint and fiber that could not be captured by the
lint filter are blocked in the filter drawer behind
the kick plate.
Clean the filter periodically when
there is visible air collection on it or when
the symbol lights up, if there is a filter drawer
cleaning warning symbol «
There is an one stage filter. This one stage filter
is from sponge
To clean the filter drawer:
Dryer / User Manual
» available.
•
Press the kick
plate button to
open the kick
plate.
•
Open the filter drawer cap turning the
cap lock on it and pull it out..
•
Clean the fluff and lint over the filter
sponge washing it with your hands.
Remove the moisture squeezing the
sponge with your hands after washing it.
•
Clean the fluff, lint and cotton pellets with
your hands or with a soft cloth.
C
NOTE
There may be no cloth in the filter cassette of
your drying machine, depending on its
model.
•
Open the filter
drawer by
pressing the red
button.
•
Take out the filter
drawer sponge.
•
If you observe a
layer over the filter
which can block
the filter, remove
the layer washing
with a water and
then cleaning it.
Dry the filter cloth
properly before
replacing the filter
drawer.
•
Place the sponge
back into its
place.
17
Hide quick links:
Advertisement
Table of Contents
