Seicane S168005 Replacement Instructions Manual

2009-2012 mazda 5 premacy aftermarket car radio upgrade

Advertisement

Quick Links

Seicane S168005 2009-2012 MAZDA 5 PREMACY aftermarket car
radio upgrade installation replacement instruction
Seicane S168005 2009-2012 MAZDA 5 PREMACY car radio after installation

Tips about the installation:

1.Please disconnect the power before the installation.
2.Please prepare a lever and a screwdriver before the removal and the installation.
3.Please keep all the separate parts from the car. Please take great care of the dashboard to avoid
scratching it during its detachment and installation. Please keep handy any parts from the car
and make use of all the original screws from the car as much as possible. so each related part of
the unit can be fixed securely.
4. For your convenience, here's the recommended tools for removal and installation from
Seicane, please check for more details:
srd-400
www.seicane.com
http://www.seicane.com/car-dvd-dismantling-device-

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S168005 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Seicane S168005

  • Page 1 Seicane S168005 2009-2012 MAZDA 5 PREMACY aftermarket car radio upgrade installation replacement instruction Seicane S168005 2009-2012 MAZDA 5 PREMACY car radio after installation Tips about the installation: 1.Please disconnect the power before the installation. 2.Please prepare a lever and a screwdriver before the removal and the installation.
  • Page 2 2009-2012 MAZDA 5 PREMACY car radio installation guide 1.Unclip and remove the cup holder panel in the center console. 2. Unclip and remove the small pocket panel on the back of the center console behind shifter. 3. Remove 2 8mm bolts under cup holder panel holding the back half of the center console to the...
  • Page 3 4. Unscrew and remove the shift knob. 5. Unclip and remove the shifter trim panel. 6. Unclip and remove the shifter trim panel. 7. Unclip and pull back the panels at the lower front sides of the center console.
  • Page 4 8. Unclip and pull back the panels at the lower front sides of the center console. 9. Unclip and remove the vent panel including the hazard switch above the factory radio. 10. Its easier to remove 2 screws by setting this piece on the top of the dash.
  • Page 5 12. Pull center console toward, this will help gain access to 2 screws under the climate controls. 13. Remove 2 screws. 14. Unclip harness and pull rear center console backwards. 15. Press in shifter release trigger and pull shifter down, make sure to have e brake on.
  • Page 6 20. Connect the Seicane car radio to your original car radio 's plugs. 21. Turn on the new Seicane radio to have a careful check if everything works well. If it doesn't, please check whether all the cables are connected correctly.

Table of Contents