Connect Alert Guard Antenna; Connect Tv Antenna; Plug In The Tv; Put Batteries In The Remote - RCA Alert Guard 24F671T User Manual

Connections & Setup
TV (back panel)
EXT
R
Alert Guard ANT
R AUDIO
Y
L
Pr
Pb AUDIO
R
Pr
TV ANT
R L/MONO
AUDIO
From Cable, Antenna,
or Satellite Receiver
ON OFF
VCR1 TV
DVD VCR2 AUX SAT•CABLE
MUTE SKIP
SOUND GO BACK
GUIDE INFO
OK
8
Graphics contained within this publication are for representation only.
L V
L/MONO VIDEO
Pb Y
VIDEO S-VIDEO IN
Arrows
OK button

Connect Alert Guard Antenna

Connect the supplied antenna, with the rod positioned
straight up and down, to the EXT Alert Guard ANT jack on the
back of the TV.

Connect TV Antenna

If you haven't already, connect the coaxial cable from your
cable source (if using the example on page 4, a VCR) to the
TV ANT jack on the back of the TV.

Plug in the TV

Plug the end of the power cord into a grounded wall outlet.
Insert the plug completely into the outlet.

Put batteries in the remote

• Remove the battery compartment cover from the back of
the remote by pushing down on and sliding off the cover.
• Insert 2 fresh "AA" batteries. Make sure the polarities (+
and -) are aligned correctly.
• Replace the cover.
How to Use the Remote Control to Complete
the Initial Setup
The technical term is "Navigation"– how you move through
the on-screen menus. The method is the same throughout
the menu screens: highlight your choice and select it.
To highlight a menu item, press the arrow buttons on the
remote to highlight one of the items listed on the screen. Use
the up or down arrow button to move up or down. Use the
right or left arrow button to move right or left.
To select the item that you've highlighted, press OK.
Note: Highlighted means that the menu item stands out from other
menu items on the list (appears darker, brighter, or a different color).
Chapter 1