Page 1: Table Of Contents
Remote and Indoor Temperatures Auto-Scanning Checking Remote Rainfall Data Maximum and Minimum Temperature Lost Communication Transmission Collision Calendar and Clock Display Modes Manual Settings Alarms Snooze Precautions Speciﬁ cations RG1736 FCC Statement User Manual Declaration of Conformity Standard Warranty Information...
Page 2: Introduction
PRODUCT OVERVIEW INTRODUCTION Th ank you for selecting the Wind & Weather Wireless MAIN UNIT—FEATURES • Wireless transmission of the rainfall data from the Rain and Temperature Monitor. Th is device monitors and displays rainfall data along with the indoor/out- remote rain gauge to the main unit up to 100 feet (30 meters) away door temperature from up to three remote locations.
Page 3 FRONT VIEW E. DOWN ( ) button (Rain Mode Control Panel) • Toggles between the rainfall modes—for past hour, for the past 24 hours, and for the past 7 days A. Weather and Time Information in a Th ree-Line • Decreases all function parameters; press and hold LCD Display LCD Display for rapid decrease...
Page 4 programming and calendar Q. REMOVABLE TABLE STAND I . UP ( ) button • Keeps main unit in upright position on a ﬂ at surface • Increases all time and temperature function parameters REMOTE RAIN GAUGE—FEATURES • Enables the time alarms •...
Page 5: Remote Rain Gauge
REMOTE RAIN GAUGE REMOTE SENSOR—FEATURES • Remote temperature transmission to the main unit via 433 MHz signal • 100 feet (30 meters) transmission range without interference • LCD display of measured temperature • Th ree transmission (3) channels selection • Selection of the temperature display in °C or °F •...
Page 6: Before You Begin
F. °C/ °F SELECTOR • Th e remote temperature sensor can be placed indoors • Selects the temperature display in °C or °F or outdoors, depending on the area where the tem- perature is intended to be measured. BEFORE YOU BEGIN •Th e main unit must be placed indoors.
Page 7: Battery Installation Remote Temperature Sensor
BATTERY INSTALLATION— BATTERY INSTALLATION— REMOTE RAIN GAUGE REMOTE TEMPERATURE SENSOR • Unlock the funnel-shaped top by turning both knobs NOTE: Install the batteries; select the channel and on the sides in a counter-clockwise direction. temperature in °C or °F before mounting the remote •...
Page 8: How To Use The Table Stand
HOW TO USE THE TABLE STAND REMOTE AND INDOOR TEMPERATURES Th e main unit has a removable table stand that supports Th e remote temperature information is located on the it on the ﬂ at surface. Attach table stand to the bottom middle line of the main unit’s display.
Page 9: Checking Remote Rainfall Data
CHECKING REMOTE RAINFALL DATA MAXIMUM AND MINIMUM TEMPERATURE Th e remote rainfall information line is located on the Th e maximum and minimum record of the indoor and top line of the main unit’s display. Th e rain icon “ ”...
Page 10: Transmission Collision
remote temperature sensor with small Phillips screw- resume once the interference subsides. driver, and open the battery compartment. • Remove the batteries and reinstall them in the same CALENDAR AND CLOCK DISPLAY MODES manner. Remote sensor LED indicator will ﬂ ash show- Date is displayed in month-date or date-month format.
Page 11: Alarms
ALARMS—HIGH RAIN ALARM the set time and alarm icon will ﬂ ash if the remote Th e high rain alarm for the past 24 hours can be set and temperature for Channel One (1) reaches 35.6°F displayed at any time by pressing ALARM button on (+2°C) and below.
Page 12: Snooze
• Press and hold the back panel ALARM button for two terials. Th ey may scratch the plastic parts and corrode secon ds. Th e “30” number will ﬂ ash, meaning that if the electronic circuits. selected, the alarm will sound 30 minutes earlier than •...
Page 13: Fcc Statement
• User-selectable (°F or °C) temperature display Dimensions • LED backlight • Main unit: 2¾"W x 5½"H • Low battery indicator • Remote sensor: 2¼"W x 4"H • Wall Mount or Desktop option • Remote rain gauge: 6½"W x 7"H Remote Rain Gauge—Remote Rainfall Data FCC STATEMENT •...
Page 14: Declaration Of Conformity
harmful interference to radio or television reception, STANDARD WARRANTY INFORMATION which can be determined by turning the equipment Th is product is warranted from manufacturing defects oﬀ and on, the user is encouraged to try to correct the for one year from date of retail purchase. It does not interference by one or more of the following measures: cover damages or wear resulting from accident, misuse, •...