Summary of Contents for ProTorc PTP Series
- Page 1 Operating Manual & Safety Instructions ProTorc Pneumatic Torque Wrench PTP Series Please read in full before operating ProTorc Pneumatic Torque Wrenches...
- Page 2 Safety This equipment should only be used by suitably trained and qualified personnel. Prior to using the equipment it is important to inspect all components to ensure that there are no signs of damage. This should include but not limited to damage to the air hoses, cracks or damage to the sockets, reaction arm or wrench itself.
- Page 3 Figure 2. Preparing the tool for operation 1. The air supply hose should be a minimum of ½” inch ID hose and rated at a working pressure of 100 psi. This should be connected to the air inlet (figure 2 – item 6). 2.
- Page 4 Fit the reaction arm to the spline of the wrench and tighten handle until tight. Make sure that the position of the reaction arm is as per figure 4 and the locking pin (figure 5) is positioned in the locator on the wrench spline (Figure 6) Figure 4.
- Page 5 Figure 6 . Using the tool for tightening (clockwise rotation) After a full risk assessment has been carried out and all PPE is in place, you are ready to proceed 1. Select the correct tool direction shown in figure 7 using the forward and reverse buttons. 2.
- Page 6 Figure 8. NOTE: The reaction arm will rotate in the opposite direction to the rotation of the socket. Using the tool for loosening (anti clockwise rotation) 1. Setting the torque as per the steps above however for loosening set the air pressure to the maximum setting as per the torque chart provided.
Need help?
Do you have a question about the PTP Series and is the answer not in the manual?
Questions and answers