System Information; Network And Internet; Device Management - youview TalkTalk Plus User Manual

22

System information

This option tells you the
Device information
manufacturer, model and serial number of your
YouView box.
This option tells you which
Software version
versions of software you currently have installed. This
will change from time to time as YouView updates
software on your behalf.
This tells you how many
Number of channels
channels you have tuned. Check here if you think you
have missing channels.
If you're having reception
TV signal quality
problems, you can check the quality and strength
of the channel you're watching. In Settings, use the
arrow key to scroll right to the TV Signal & Quality
option, then press OK.
If you are using a
Network connection status
broadband router, this setting will show you the status
of your connection. It will also give you information
about that connection, such as the IP address. You
can change this information in Network and Internet
settings.

Network and Internet

Access this section if you want to check your Wired
Connection settings are set to "Automatic" and
your YouView box will detect your settings. This
option is the default setting and is considered to be
appropriate for most users.
However, if you prefer, you can change this setting to
'Manual'. You can then enter the IP address, Subnet
Mask, Default Gateway, Primary DNS Server and
Secondary DNS Server yourself. (If you don't have this
information, please go to talktalk.co.uk/tvhelp)

Device Management

By default, your YouView
Auto delete recordings
box is set to delete old recordings automatically when
the hard disk runs out of space. However, to prevent
this, use the arrow keys to select ON or OFF.
YouView will automatically update
Software update
your software. You can use this setting to check for
updates manually.
Checking for updates
Update On demand players
to On demand players is performed automatically.
However, you can check for updates yourself by
pressing CHECK NOW.
Use this option if you want
Reset your YouView box
to reset your YouView box and restore it to its factory
settings. However, this will also reset your PIN, any
preferences you have set, delete your postcode and
all your current and future recordings and reminders.
Warning Resetting your YouView box will
delete all of your recordings and cancel any
reminders that you've set.
This option controls when
Automatic standby time
or if your YouView box should go into standby mode.
By default, it will go into standby after 3 hours if you
have not interacted with it.
Change default settings: Press on Automatic
OK
Standby Time and use the arrow keys to select
2, 3, or 4 hours.
Use this option to manage the energy
eco mode
settings for your YouView box. By default, this is set to
HIGH, the most energy efficient mode.
By changing this setting to low your YouView box
will only go to active standby which is less energy
efficient but will ensure the start up time from
standby is greatly reduced.
Use this option to enable the
RF loop through
Antenna Out connection on your YouView box.
By default, this is set to OFF.