Summary of Contents for Jesmay Electronics JM2318R
- Page 1 2.4GHz Digital Wireless A/V Sender OWNER’S MANUAL PLEASE READ BEFORE USE PLEASE CONSULT THE BACK COVER OF THIS OWNER’S MANUAL FOR MODEL AND FEATURE...
-
Page 2: Important Safety Precautions
A. Checking Contents of Box Important-Safety Precautions Checks and make sure that all of the items shown as below are included with your 2.4 GHz Digital Wireless A/V Sender System. If something is missing, To prevent fire or shock hazard, do not expose this device to rain or moisture. please contact your dealer as soon as possible. - Page 3 B. Introduction to 2.4GHz Digital Wireless A/V Sender The Using Attention The outlet of the power supply must have the same voltage as the Congratulations on purchasing this 2.4GHz Digital Wireless A/V local area. Sender. This sender system is a digital wireless audio/video sender 1.
- Page 4 device with clothes or other things. REAR VIEW FOR RECEIVER CH4 (NTSC only) C. Product Layout The following illustrations and show the names of each component, button and switch connectors on the transmitter and receiver. RF output to TV 2.4G Antenna FRONT VIEW (e.g.
-
Page 5: Video Sources
with the following instructions to the matching code. Please see the follow pairing operation. 1. The first, push the power switch of transmitter and receiver and turn on both power switch. Then you can press the PAIR button on the front of the transmitter and not release until the LINK LED on the front of the transmitter begins to flash then you can release the PAIR button, and then the transmitter starts to enter the pairing state and automatically link ID code to the receiver. - Page 6 connecting them to your VCR. To transmit directly from your satellite receiver, If your VCR has only SCART socket for audio/video output, you can use a follow the instructions below. SCART/RCA adapter (not included) to connect the RCA plug of the 1.
- Page 7 · Connect the receiver directly to the remote TV. VCR and also enjoy the picture and sound on a remote TV at the same time. · Connect the receiver to a VCR, which is then connected to the TV. 1. Connect VCR and receiver with RCA cable, just plug RCA plugs to the RCA input of VCR.
-
Page 8: Troubleshooting, Care And Maintenance
source using your existing remote control device. It converts the infrared (IR) signal emitted by your remote control to a radio frequency (RF) signal in the receiver and sends it back to the transmitter where the RF signal is converted back to the original IR signal and control the audio/video source such as DVD ,VCR , etc. - Page 9 Maximum Transmit Power 50mW Problem Possible solutions Modulation 16QAM/QPSK/BPSK Video Input Level 1V p-p 75 ohm Check all cable connections. No picture or sound Make sure power plugs are pushed all the way in. Audio Input Level 1V p-p 600 ohm (STEREO) Check power switches on the remote TV and Antenna...