Advertisement
�
PR-20
Bolt Printer
Operator's Manual
Printer attaches to top of Auto Meter SB-300, RC-300, BVA-300, and
BVA-350 Hand Held Testers.
The PR-20 printer simply slides over the hand held tester to become a
portable single unit tester / printer that allows for individual test printouts
with complete test results.
12
T est Equipment
Advertisement
Table of Contents
Related Manuals for Auto Meter PR-20
Summary of Contents for Auto Meter PR-20
- Page 1 Printer attaches to top of Auto Meter SB-300, RC-300, BVA-300, and BVA-350 Hand Held Testers. The PR-20 printer simply slides over the hand held tester to become a portable single unit tester / printer that allows for individual test printouts with complete test results.
- Page 2 CONTENTS NOTES Specifications ................3 Installation .................. 4 Controls & Functions ..............5 Printer Operation ................ 6 Paper Replacement ..............7 Charging the Battery..............8 Replacing the Battery ..............9 Warranty ................... 10 Contact Information ..............12...
- Page 3 LIMITED WARRANTY CONGRATULATIONS! You have purchased Auto Meter’s Bolt Printing solution designed to be installed over the top of your SB-300, RC-300, BVA-300, and BVA-350 hand held testers. Pressing the “Print” 12 MONTHS FROM DATE OF PURCHASE button on your tester sends the print job to the printer using a wireless...
- Page 4 REPLACING THE BATTERY Installing the Printer to Your Hand Held Tester If you notice that the battery life is becoming shorter 1. Remove the printer from the rubber boot. between battery charges, the battery may be coming to 2. Slide printer over the top of the hand held tester. the end of its useful life.
- Page 5 CHARGING THE BATTERY CONTROLS & FUNCTIONS The “Power” LED will turn from green to amber when Power LED the internal printer battery needs to be charged. Green = Ready Amber = Recharge 1. Plug the battery charger into the printer charging port located Paper Roll Battery in the smaller rubber boot hole on the right side of the printer.
- Page 6 The “Printer Ready” LED will turn from green to amber when paper needs replacement. 1. After performing a test using your tester. Turn on the PR-20 printer 1. Open cover by placing hands on both sides of the by pressing the “Power” button.
Need help?
Do you have a question about the PR-20 and is the answer not in the manual?
Questions and answers