Maintenance; Starting A Warm Engine; Starting A Flooded Engine; Operating Instructions - Poulan Pro PR 2322 Instruction Manual

1
OFF
ON
(STOP)
(RUN)
6
2
Throttle Control Positions
FULL CHOKE
NO CHOKE
1. Move the choke control (3) to the FULL CHOKE
position.
2. Slowly press the primer bulb (2) 10 times.
3. Squeeze the throttle trigger (5), press the fast idle
button (6), and release the throttle trigger so the fast
idle button stays engaged.
4. Pull the starter rope handle sharply 5 times or until the
engine starts.
5. Allow the engine to run 5 seconds.
6. Move the choke control to the NO CHOKE position.
7. If the engine is not currently running or has stalled, pull
starter rope handle sharply until the engine runs.
8. Allow the engine to run 15 seconds.

STARTING A WARM ENGINE

1. Move the choke control to the NO CHOKE position.
2. Pull starter rope handle sharply until the engine runs.
NOTE: If engine still does not run, it is probably
flooded. Proceed to STARTING A FLOODED ENGINE.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing the ON/
OFF switch in the ON position and the choke lever in
the NO CHOKE position; then, pull the rope to clear the
a WARNING: Ensure ON/OFF switch is in the
OFF position and disconnect the spark plug
before performing maintenance except for
carburetor adjustments.
GENERAL RECOMMENDATIONS
The warranty on this unit does not cover items that
have been subjected to operator abuse or negligence.
To receive full value from the warranty, the operator
4
3
5
FULL CHOKE
NO CHOKE

MAINTENANCE

engine of excess fuel. Starting could require pulling the
starter rope many times depending on how badly the
unit is flooded. If the unit still doesn't start, refer to the
TROUBLESHOOTING TABLE or call 1-800-487-5951.

OPERATING INSTRUCTIONS

It is recommended that the engine not be operated for
longer than 30 seconds at full throttle. Releasing the
trigger and allowing the engine to briefly return to idle
speed (5 - 10 seconds) will be sufficient.
IMPORTANT POINTS
• Use the minimum throttle speed necessary to effectively
cut hedges for optimal hedge trimmer performance.
OPERATING POSITION
HANDLE LEVER
The handle lever can be used to rotate the rear handle to
allow operation of the unit at a 45° and 90° position.
1. Allow engine to return to idle speed.
2. Pull handle lever and rotate rear handle to desired
position.
3. Release handle lever.
STOPPING THE ENGINE
To stop the engine, press the ON/OFF switch (1) to the
OFF position.
ON
(RUN)
6
must maintain unit as instructed in this manual. Various
adjustments will need to be made periodically to properly
maintain your unit.
CHECK FOR LOOSE FASTENERS AND PARTS
• Spark Plug Boot
• Air Filter
• Housing Screws
1
OFF
(STOP)
5
2
NO CHOKE
4
3
FULL CHOKE
5