1. Manuals
  2. Brands
  3. Rio Grande Manuals
  4. Hot Tub
  5. CSCHTRG29
  6. Manual

Rio Grande CSCHTRG29 Manual

110-115v 60hz 15 amp
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Rio Grande
P O R T A B L E S P A
110-115V 60Hz 15 amp
Read this manual before operation
Rio Grande
P O R T A B L E
w w w . c a n a d i a n s p a c o m p a n y . c o m
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CSCHTRG29 and is the answer not in the manual?

Questions and answers

Summary of Contents for Rio Grande CSCHTRG29

  • Page 1 Rio Grande P O R T A B L E S P A 110-115V 60Hz 15 amp Read this manual before operation Rio Grande P O R T A B L E w w w . c a n a d i a n s p a c o m p a n y . c o m...

  • Page 2: Important Safety Instructions

    IMPORTANT SAFETY INSTRUCTIONS READ AND FOLLOW ALL SAFETY INSTRUCTIONS: Basic safety precautions should always be followed when installing and using this electrical equipment. WARNING: The spa has been supplied with a residual operating current not exceeding 30 mA. The GFCI must be tested before each use. WARNING: No part of the appliance is to be located above the spa during use.
  • Page 3 IMPORTANT SAFETY INSTRUCTIONS CAUTION: Always consult your doctor before: a) The use of alcohol, drugs, or medication, before or during spa use may lead to unconsciousness with the possibility of drowning. b) Obese persons and people with a history of heart disease, low or high blood pressure, circulatory system problems, or diabetes, should consult a physician before using a spa.

  • Page 4: Package List

    Part 1: PACKAGE LIST Parts: Rio Grande Inflatable Spa Take all the Spa components out of the box and check your Instruction Manual that all the following key components are present: Box Includes: A) Spa /Liner (with integrated Control Unit Connectors)

  • Page 5: Specifications

    Part 2 : SPECIFICATIONS Item: CSCHTRG29 Seating Capacity 4 Persons Spa Dimension 70’’x 29’’ (180 x 74cm) Water Capacity Up to water line indicators Voltage 115V 60Hz Heater 1340W Massage Jet Pump 500W Filter Pump Max. Heat Temperature 104°F (40°C)
  • Page 6 2. Test GFCI & Inflate Lid a) Perform GFCI Test WARNING: RISK OF ELECTRIC SHOCK. The GFCI plug must be tested before each use. Do not use if GFCI test fails. 1. Insert the plug into the power outlet. 2. Press the “RESET“ button, the indicator light turns red. 3.
  • Page 7 4. Connect the Portable Control Unit to the Spa Position the Portable Control Unit next to the spa, remove the Inflation Hose and align the Connection Hoses to the spa. Ensure that the hoses have ‘O’ ring gaskets inserted correctly (see fig.

  • Page 8: Pre-Fill Check

    5. Install the Filter Cartridge Open the Filter Housing lid counter-clockwise. Put the new filter cartridge into the cartridge chamber and close the lid clockwise. Ensure black “O” ring is placed correctly inside housing. 6. Pre-Fill Check Ensure the drain outlet is extended for future draining/access (Fig. A), check that the washer is in the cap, then tighten.

  • Page 9: Water Maintenance

    Cleaning / Replacing Filter Cartridge WARNING: RISK OF ELECTRIC SHOCK. Unplug the pump before beginning spa maintenance. Note: A dirty filter cartridge may contaminate the spa water and cause damage to the heating function. 1. Carefully thread the three plastic caps onto the inlet/outlet ports on inner spa wall. 2.

  • Page 10: Drain & Store

    Part 6: DRAIN & STORE Drain System Locate and remove the external threaded Drain Cap. Attach Drain Hose to Drain Outlet. Locate and remove the stopper on the spa floor to allow water to drain. Dry the Spa and Portable Control Unit After a GFCI test, press the Jet Massage Button to blow out the water inside the jet holes.
  • Page 11 Part 7 PORTABLE CONTROL UNIT FUNCTION F. LED Display G. Temperature Mode Button B. Temperature Decrease A. Temperature Increase Button Button D. Filter Button C. Blower/Jet Massage Button E. Heat Button Functions of the Spa Portable Control Unit • LED Display: Once powered-up, the LED display will show the current water temperature automatically.
  • Page 12 Part 8 : PCU ERROR MESSAGES CODE Causes Solutions Temperature control 1. Unplug GFCI from outlet E1/ E2 sensor short circuit 2. Please contact for service or open circuit 1. Unplug the GFCI cable from the outlet High Heat: 2. See Part 9: Spa Operation Check List for possible solutions The water is 3.
  • Page 13 Part 9 : SPA OPERATION CHECK LIST CHECK 1 - Water Level Ensure water level meets fill lines on both interior sides of the spa. Check if this resolves the pump’s malfunctioning. CHECK 2 - Inside Connection Caps Make sure the clear plastic connection caps have been removed before turning on the pump.
  • Page 14 Part 10 : FREQUENT PROBLEMS SOLUTION Problems Causes Solutions Spa Pump • GFCI tripped • Power failure Does Not • GFCI broken • Reset GFCI/check if the cable is rated 2kW / 15A Operate • Check power source • Call for service if it does not reset •...
  • Page 15 Accessories (0ptional) 3 Pack Filter (Buy 3 Get 1 Bonus) 3 x 15 ft² slip replacement filters for Canadian Spa Company portable spas. This filter should be changed every 1-2 months (depending on usage). Portable Chemical Kit: This chemical kit is an excellent addition to any spa and provides users with all of the essential spa chemicals needed to keep a spa balanced.
  • Page 16 INFORMATION: To register your warranty: http://www.canadianspacompany.com/support/warranty-registration/ North America Office: UK Office: German Office: Asia Office: Canadian Spa Company Canadian Spa Company Lützerathstrasse 127 Canadian Spa Company 2-3620B Laird Road Canada House 51107 Köln No.460 Lanxue Road,Huanglou, Mississauga, Ontario Salbrook Road T:0049-221-94655344 Pudong Area Shanghai,P.R.China Canada, L5L 6A9...

Table of Contents