Summary of Contents for SERO DS-045
- Page 1 Edited by Foxit PDF Editor Copyright (c) by Foxit Software Company, 2004 - 2007 For Evaluation Only. OPERATION MANUAL DEHUMIDIFIER Please read this operation manual before using the dehumidifier...
-
Page 2: Table Of Contents
CONTENTS Safety Instruction Attention during Usage Principle of dehumiditifier Specification Descriptions of Parts Panel Controll 9-10 Remote Controller Operation Guide AUTO Operation Mode Air Direction Adjustment Timer Operations Defrost system Water drainage system Error codes Wiring diagram 17-19 Maintenance Trouble Shooting... -
Page 3: Safety Instruction
Safety Instruction Please read the following Safety Instructions carefully prior to use. The instructions are classified into two levels, WARNING and CAUTION according to the seriousness of possible risks and damages as follows. Compliance to the instructions are strictly required for safety use. Installation WARNING Please call Sales/Service Shop for the Installation. -
Page 4: Attention During Usage
Attention during Usage WARNING Never use damaged electric Ensure the power plug is secure Never pull out the power plug wires or unspecified electric If the plug is not secure, it may during operation. otherwise, it may cause a elec- wires. -
Page 5: Attention During Usage
Attention during Usage Switch off the power supply If the air-conditioner is not in Do not hold the electric wire to w h i l e c l e a n i n g t h e d e - use for a long time, it is neces- pull out the power plug. -
Page 6: Principle Of Dehumiditifier
The dehumidifier use the refrigeration circuit to change the damp air warm dry air. When the damp air passes the condenser, the air water will be condensed and the air will become dry. The Specification Of Dehumidifier (R410a) DS-045 DS-060 DS-080 DS-011... -
Page 7: Descriptions Of Parts
Descriptions of Parts Air Outlet Control Panel Air filter(inside) Air Inlet SWING SWING TIMER HEATER MODE ON/OFF SPEED Humidity sensor Indoor temperature sensor Water drainage system Four way valve Compressor... -
Page 8: Panel Controll
Panel Control Signal Receiver Display Button SWING SWING TIMER HEATER MODE ON/OFF SPEED Button Press the button to start operation, Mode is selected in a sequence: ON / OFF MODE press the button again to stop operation. Automatic ; Dehumidifying ; Fan ; Heating. -
Page 9: Remote Controller
Remote Controller Signal Emitter : Sending out remote control signal Temperature Adjustment Button : to the air-conditioner Adjust temperature settings Press once to set temperature 1 degree higher. Press once to set temperature 1 Remote Controller Display Panel : Display settings degree lower. - Page 10 Remote Controller Emission Indicator : This symbol flashes once when the Remote Controller emits signals to the Dehumidifier. Mode Display : Press "Mode" button to display the current working mode. Automatic, Temperature Display : Heating, Dehumidifying, Fan modes It displays the current set tempera- ture which may be adjusted by Tem- perature Adjustment Button within the range of 18 ~30 C.
-
Page 11: Operation Guide
Operation Guide Proper settings of Heating, Dehumidifying and Fan modes Mode Selection ( 1 ) Press "Mode" button to select the required working mode, which is changed in the following sequence when pressed once: Automatic Dehumidifying Heating COOL TEMP NOTE: Heating mode is available only on cooling-heating type air conditioner. -
Page 12: Auto Operation Mode
AUTO Operation Mode Automatic operation Mode Mode Selection (1) Press "Mode" button to select Automatic Operation mode. AUTO Fan Selection (2) TEMP Press "FAN" button to select the required amount of air flow, which is changed in the following sequence when pressed once : AUTO FAN High Automatic... -
Page 13: Air Direction Adjustment
Air Direction Adjustment Up-Down Air Direction Adjustment SWING SWING TIMER HEATER MODE ON/OFF SPEED Airflow horizontally Airflow upward Airflow downward NOTE: To stop the up-down air louver in a desired position, set the louver to automatic swinging and when it reaches the desired position, stop the louver from swinging. It is necessary to adjust the louver angle by means of the remote controller, Setting of the louver with the hand may affect its normal operation, in which event, switch off the unit temporarily and re-start operation. -
Page 14: Timer Operations
Timer Operations Timer Switch On 1. Press "Timer On" button to set time for timer-on switching. Press button once change time interval hour cyclic manner ...12 ..1, 2..5, (The display showing previous time starting time present setting) If the button is held down, the time interval will increase progres- COOL TEMP sively by 1 hour unit. -
Page 15: Defrost System
Defrost system Sequences of the defrosting: 1- Start The defrosting is engaged if the following conditions are at the same time fulfiled: - the compressor and the fan motor run without stopping; - the defrosting sensor temperature lower than 3 , and the duration of time more than 45 minutes;... -
Page 16: Error Codes
Error Codes E1 : Room temperature sensor error; E2 : Defrost temperature sensor error; E3 : Humidity sensor error; E4 : Drain error; SWING SWING TIMER HEATER MODE ON/OFF SPEED Wiring diagram WIRING DIAGRAM Synchronization STEP MOTOR MOTOR MOTOR COMPRESSOR PUMP WHITE AC-N2... -
Page 17: Maintenance
Maintenance For smart use of the Dehumidifier: Setting of proper room Do not block the air inlet temperature or outlet Proper temperature Close doors and windows Use the timer effectively during operation If the unit is not to be used Use the louvers effectively for a long time, turn off the power supply main switch. - Page 18 Maintenance For smart use of the Dehumidifier: WARNING Before maintenance,be sure to turn off the system and the circuit breaker. Remote Controller Body Wipe the air conditioner by using a soft and Do not use water, wipe the controller with a dry cloth.For serious stains,use a neutral dry cloth.Do not use glass cleaner or chemical detergent diluted with water.Wring the water...
- Page 19 Maintenance To keep your Dehumidifier in good condition after season: 1. Operate in FAN mode for about half a day. On a fine day, unit shall be started and operate in FAN mode for about half a day until the inside of the unit becomes thoroughly dry.
-
Page 20: Trouble Shooting
Trouble shooting Before asking for service, check the following first. Phenomenon Cause or check points When unit is stopped, it won't restart The system does not restart immediately until 3 minutes have elapsed immediately. to protect the system. When the electric plug is pulled out and reinserted, the protection circuit will work for 3 minutes to protect the dehumidifier.
Need help?
Do you have a question about the DS-045 and is the answer not in the manual?
Questions and answers