NINGBO WELL ELECCTRIC APPLIANCE LS-01RD Installation Instructions

LED STRING LIGHT INSTALLATION INSTRUCTIONS
WARNING: When using electrical products, basic precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
Do not use these products outdoors unless marked suitable for indoor and outdoor use. When products are used
in outdoor applications, connect the product to a Ground Fault Circuit Interrupting(GFCI) outlet. If one is not provi-
ded, contact a qualified electrician for proper installation.
Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of heat.
Do not let lamps rest on the supply cord or on any wire.
Do not use this product for other than its intended use.
Do not hang objects from cord, wire, or light string.
Do not close doors or windows on the product or extension cords as this may damage the wire insulation.
Do not cover the product with cloth, paper or any material not part of the product when in use. This product is
equipped with push-in type lamps. Do not twist lamps. It is acceptable to omit this item if the product does
not contain push-in type lamps. This product employs overload protection(fuse). A blown fuse indicates an
overload or short-circuit situation. If the fuse blows, unplug the product from the outlet. Also unplug any
additional strings or products that maybe attached to the product. Replace the fuse as per the user servicing
instructions(follow product marking for proper fuse rating) and check the product. If the replacement fuse
blows, a short-circuit may be present and the product should be discarded. It is acceptable to omit this item if
the fuse is not replaceable or where overload protection is not required.
POWER SUPPLY
CAUTION: Risk of electric shock. Avoid making connections or disconnections when the equipment is wet.
Do not use with extension cord near water or where water may accumulate. Do not submerse.
CAUTION - To reduce the risk of fire, electric shock or injury to persons:
1. SUNBEAM Electric String Lights are intended for installation indoor or outdoor.
2. String Lights must be supported by steel guide cables or other suitable supporting hardware such as
s-hooks,screw hooks or zip ties(not included) whenever span distances exceed twenty
four feet. See Installation Methods on page 4.
WARNING: - RISK OF ELECTRIC SHOCK!!
Disconnect power supply at source prior to wiring,replacing light bulbs or servicing in any way.
BULB REPLACEMENT
1.Unscrew fixture nut counter clock-wise
2.Insert new bulb aligning guide on module to groove inside
socket.
3.Screw in fixture nut clock-wise.
Includes two extra bulbs.
Bulbs last up to 25,000 hours.
Additional bulbs available at
WWW.SUNBEAM.COM
MODEL:LS‐01RD NINGBO WELL ELECCTRIC APPLIANCE CO,.LTD
IMPORTANT SAFETY INSTRUCTIONS
1 / 4
SAVE THESE INSTRUCTIONS