Quick Installation Guide 8~14-Port Managed Ethernet Switch Quick Installation Guide Overview The Managed Ethernet Switch solutions are designed for supporting standard industrial applications. Managed switches are easier to prioritize, partition, and organize user’s network, providing a more reliable and better quality services. Package Checklist Please verify the box contains the following items: Item...
Quick Installation Guide Safety Instructions When a fiber connection is removed during installation, testing, servicing or an active fiber is broken, ocular exposure to optical energy may be potentially hazardous, depending on the laser output power. The primary hazards of exposing laser radiation from an optical-fiber communication systems are: ●...
Quick Installation Guide DIN-Rail Mounting Mounting steps: 1. Screw the din-clip with screws in the accessory kit. 2. Hook the unit onto the din-rail. 3. Push the bottom of the unit towards the din-rail until it locks in place. Wall Mounting Mounting steps: 1.
Quick Installation Guide Ethernet Interface (RJ45 Ethernet) The switch provides two types of Ethernet interfaces: electrical (RJ45) and optical (SFP) interfaces. Connecting the Ethernet interface via RJ45: ● To connect the switch to a PC, use straight-through or cross-over Ethernet cables, ●...
Quick Installation Guide Connecting Power Terminal Block The switch can be powered from two power supplies (input range 12V – 58V). Insert the positive and negative wires into V+ and V- contacts on the terminal block respectively and tighten the wire-clamp screws to prevent the wires from being loosened.
Quick Installation Guide Alarm Relay and Ground The alarm relay output contacts are in the middle of the DC terminal block connector as shown in the figure below. The alarm relay out is “Normal Open”, and it will be closed when detected any predefined failure such as power failures or Ethernet link failures.
Quick Installation Guide To connect the host PC to the console port, a RJ45 (male) connector-to-RS232 DB9 (female) connector cable is required. The RJ45 connector of the cable is connected to the CID port of IVS-500; the DB9 connector of the cable is connected to the PC COM port. The pin assignment of the console cable is shown below: Connect &...
Quick Installation Guide Login with default account and password. Username: admin Password: (none) Change the IP with commands listed below: CLI Command: enable configure terminal interface vlan 1 ip address xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx exit LED STATUS INDICATIONS LED Name Indicator /color Condition On Green P1/P2 power line has power...
Need help?
Do you have a question about the MLB-E42**-P Series and is the answer not in the manual?
Questions and answers