Page 8
Certain steps in the instructions are only presented in the form of images. Explanatory text is also given for more complicated steps. In the event of any problems with the instructions or the accessory, contact your local Volvo dealer. Note! This accessory requires software unique to the car. Note! Steps 2-5 and 18 only apply to the S60, V70 and XC70.
Page 9
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Preparations S60/V70/XC70 Preparations S60/V70/XC70 Illustration A applies to cars up to and including model year -2004 (S60 CH -424999, V70 CH -458999, XC70 CH - 172999) Remove the cover panel in front of the gear selector lever by prizing it away with a plastic weatherstrip tool as illustrated.
Page 10
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Illustration A applies to cars up to and including model year -2004 (S60 CH -424999, V70 CH -458999, XC70 CH - 172999) Remove the two screws from the dashboard environment panel. Illustration B applies to cars from model year 2005- (S60...
Page 11
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden If any of the outer hooks fail then this must be rectified. See the section on the dashboard in the Workshop Manual in VIDA. Illustration B applies to cars from model year 2005- (S60...
Page 12
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Preparations S80 Detach the panel (1). Detach the gear selector lever boot using a weatherstrip tool. R8504614 Move the gear selector lever to its rearmost position. Pull the panel (1) with the boot backwards as far as possible.
Page 13
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Angle the dashboard environment panel outwards so that it is possible to insert a couple of fingers between the centre console and the short side of the dashboard environment panel. Pull the dashboard environment panel downward maintaining the same angle and remove the dashboard environment panel.
Page 14
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all models: Installing the amplifier Remove the covers (1) for the screws to the right-hand seat. Remove the screws (2) from the seat base. Unplug the connectors under the seat.
Page 15
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Connect the thick cable harness from the kit to the sockets in the amplifier. If there is a pre-routed cable (2) to the power supply under the right-hand seat, connect it and then skip over steps 14 - 17. If not, connect the cable from the kit for the power supply to the amplifier.
Page 16
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Route the ground lead (1) for the power supply (brown) under the carpet in the rear edge of the member for the front seat mounting, out to the right-hand side of the door sill.
Page 17
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Note! On right-hand drive cars the fuse holder is located on the right- hand side. The positive cable is then routed the same way as the ground lead, and up from below along the A-pillar to the fuse holder.
Page 18
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to cars up to and including model year -2004 (S60 CH -424999, V70 CH -458999, XC70 CH -172999, S80 CH - 389999) Install a 30A fuse in position 17. Applies to cars from model year 2005- (S60 CH 425000-, V70 CH 459000-, XC70 CH 173000-, S80 CH 390000-) Install a 30A fuse at position 11.
Page 19
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Applies to all models Reinstall the carpets. Plug in the connectors to the seat and reinstall it. Screw in four new screws to the seat frame, tightening torque 40 Nm (30 lbf.ft.).
Page 20
Installation instructions, accessories Volvo Car Corporation Gothenburg, Sweden Reinstall the sill moulding. Applies to all models Applies to all models Turn the ignition key to position II. Reconnect the battery negative lead Programme the software in accordance with the service information in VIDA.
Need help?
Do you have a question about the SRS V70 and is the answer not in the manual?
Questions and answers