Setup Sensor - Oregon Scientific MSR939 User Manual

SETUP SENSOR

1. Install the batteries.
2. Set the channel by sliding the CHANNEL switch to
1 or 2. The switch is located in the battery
compartment.
SWITCH OPTION
Channel Channel 1-2. If you are using more than
one sensor, select a different channel
for each sensor.
3. Set the Code by sliding the CODE switches to the
same setting as the Code on the clock display. This
enables the clock and motion sensor to interact with
each other.
4. Press the RESET button. Close the motion sensor
battery compartment.
5. Secure the sensor in the desired location using the
wall mount or table stand.
6. Twist the rotary motion sensor knob to direct the
sensor to the position you want.
7. Slide the POWER ON / OFF switch to turn the motion
sensor ON or OFF.
8. Slide the ALARM SOUND ON / OFF switch to ON to
activate the alarm sound function. The motion sensor
alarm will now sound for 20 seconds if it detects
movement. Slide to OFF to deactivate this function.
MSR939 English R0
NOTE
2 minutes to warm up.
For best results:
You may need to experiment with various locations to
get the best results.
NOTE
(RMR939P) manual for information on the remote
sensor's clock controlled functions.
7
7
Once it has power, the motion sensor takes
• Insert the batteries and select the channel before
you mount the sensor.
• Place the sensor out of direct sunlight and
moisture.
• Do not place the sensor more than 30 metres
(98 feet) from the main (indoor) unit.
• Position the sensor so that it faces the main
(indoor) unit, minimizing obstructions such as
doors, walls, and furniture.
• Place the sensor in a location with a clear view to
the sky, away from metallic or electronic objects.
Please refer to the RF Projection Clock
7/19/04, 1:51 AM