Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Franklin EF1-230V
- Page 1 EF1-230V Hand-Held Welder Operating Manual For use Only with UPP™ Electrofusion Components Franklin Fueling Systems • 3760 Marsh Rd. • Madison, WI 53718 USA Tel: +1 608 838 8786 • 800 225 9787 • Fax: +1 608 838 6433 • www.franklinfueling.com...
-
Page 2: Liability Restrictions
UPP™ welding units must never be operated in Zone1 Warning or Zone 0 areas! Hazardous area definitions are from European Directive 1999/92/EC (further guidelines can be found in the APEA Blue Book 2nd Edition).Further guidelines are found in IEC 60079-10-1, “Explosive atmospheres - Part 10-1: Classification of areas - Explosive gas atmospheres”... -
Page 3: Technical Specifications
Technical Specifications Stock code _________________ EF1-230V Supply voltage ______________ 230 V +/- 15% (194 V to 264 V) Supply frequency ____________ 50/60 Hz (40 Hz to 70 Hz) Supply power _______________ 2.8 kW / 3.5 kVA Supply protection ____________ Class 1 earthed (grounded) Environmental protection ______ IP65 Operating temperature ________ -15 ºC (5 ºF) to +45 ºC (113 ºF) - Page 4 Note: EF1 welding cables use special 7 pin connectors. Parts Bridging cables (x2) Electrofusion Welder 7pin Secondary welding cable 7 pin Primary and Gemini Secondary welding cable Power cable 7 Pin Fusion chamber welding cable Application The EF1 is designed to automatically weld UPP™ Primary and Secondary Containment electrofusion fittings, Electrofusion Chambers and Large diameter 10 amp fittings.
-
Page 5: Main Features
Main Features UPP™ electrofusion fittings are welded using a constant current. The EF1 automatically recognizes the fitting when connected and applies the correct amount of energy for a successful weld. 7 pin Weld cable Power on Indicator connector ON / OFF Switch (on Fault side of unit) indicator... -
Page 6: Other Important Tips
Using the EF • Ensure that the machine is positioned outside hazardous zones ATEX 0, 1 and 2. • Allow the machine and fittings to reach the ambient temperature of the site. • Keep the machine out of direct sunlight and free of any obstruction. •... -
Page 7: Maintenance
• Electrical Safety Testing “Portable Appliance Test” (PAT) should be carried out in accordance with local legislation. • It is recommended that the welder is returned to Franklin Fueling Systems on a regular basis, at around 3 year intervals, for checking and recalibrating. -
Page 8: Fault Indicators
Fault Indicators When an error has occurred during the weld cycle that will have an effect on the success of the joint, the red warning LED on the right side of the display will light up. Also one of the “weld progress” lights will light up at the same time to show what type of fault has occurred. -
Page 9: Declaration Of Conformity
• 2004/108/EC Electromagnetic compatibility. • 2006/95/EC Low voltage equipment. • 98/37/EC Machinery safety. • 94/62/EC Packaging and packaging waste. • 2008/34/EC Waste electrical and electronic equipment. • 2008/35/EC Restriction of hazardous substances. Andrea Ticci Signed on behalf of Franklin Fueling Systems... - Page 10 Page intentionally blank...
- Page 11 Page intentionally blank...
- Page 12 ©FFS 2014 408001010 Rev4...
Need help?
Do you have a question about the EF1-230V and is the answer not in the manual?
Questions and answers